Microtek CX4 manual Turning The Equipment On And Off

Turning The Equipment On And Off

Turn on the projector and any video players in the following sequence:

1.Video Signal Source equipment

2.Audio Signal Source equipment (If it is different with a computer or video signal source)

3.Projector

4.External Speaker

5.Computer

Remove the lens cover before the projector is turned on. When the power source is connected, the Power Led Indicator will first blink for a few seconds and will be fully lit when the connection of the power source is completed. If the computer and the Video Signal Source are connected, an image depicting a computer or a Video Signal Source will be displayed. It will take at least 30 seconds to display a regular image after the power has been connected.

Warning:

When the lamp is turned on, never let yourself or let children look into the lens of the projector. The bright light emitted from the lamp into the lens of the projector will seriously damage the eyes.

Attention:

Remove the lens cover before the projector is turned on as the strong light emitted from the lamp will damage the lens cover permanently.

To turn the projector and its accessory equipment off, please operate the above steps in reverse order.

Attention:

When the power source is disconnected, the built-in fan will continue to operate in order to cool down the projector, and the Power Led indicator will turn orange and blink for two minutes. When the projector -has cooled down, Power Led indicator will remain lit in green. If the projector is turned on during Power Led indicator is blinking in orange, the projector will not be able to display images.

Attention:

24