Microtek CX4 manual Using The Osd Menu

Page 33

USING THE OSD MENU

USING THE OSD MENU

The functions offered by the OSD menu of this projector are as follows:

Adjusts the input signal of the projected image in its brightness, black level, contrast, position and the interface of the remote-control mouse.

Adjusts the input signal of the projected image in its phase & tracking (Image), sharpness, saturation, hue and Flash Tone(Video). Adjusts the volume and to select the type of input signal.

Selects the projection mode in front, ceiling, rear and ceiling & rear projection; to select the language, the content of the input signal and the consumed lamp life (Information).

Revise and save the settings of OSD menu. Keystone correction (Keystone)

32

Image 33

Contents Page INTRODUCTION Safety Instructions If the power cable or plug is damaged or frays Where To Get Help Transporting Your Projector Remote Control InformationWarning： Remote Control Briefing FunctionsINSTALLATION Unpacking The Projector Setting Up The Projector Do not mix used and new batteries Connecting To A Desktop Computer Connecting To A Computer8. Tighten all connector screws to ensure secure connections 4. Connect the Control Cable to the Control port of the projector5. Remove the computer mouse cable Connecting To A Notebook DVI SourceData Projector Connecting To A Macintosh Desktop Computer Connecting To A Macintosh PowerBook Connecting To A Set-top Box Connecting To A Video Source The steps of connecting the projector to the video source Page Connection of an audio cable from a computer source Connecting To An Audio SourceConnection of an audio cable from a video audio source Connecting To An External Speaker Speaker or PAData Projector THIS PROJECTOR HOW TO OPERATETurning The Equipment On And Off Page The Focus and Zoom Functions How To Adjust The Projected ImageThe Resize key The Auto KeyHow To Operate This Projector Buttons The Buttons on the Operation Panel of the Projector & Their FunctionsFunctions likeNote The ZOOM & FOCUS functions are not suitable to this model The Buttons on the Remote Control & Their FunctionsExamine The Projector Status The life of the lamp will soon end, please prepare aThe life of the lamp has ended, please replace with USING THE OSD MENU How To Change OSD Settings How To Access The OSD MenuOSD Menu BrightnessContrast Black LevelPosition ImageAuto Configuration InformationMiscellaneous Input Select VideoSave Keystone VolumeProjection Mode MouseLanguage MAINTENANCE Cleaning the Projector Case Cleaning the LensCleaning the Air Filter The Steps of Cleaning the Air FilterThe Steps of Replacing a Lamp Replacing The Projector Lamp1. Turn the power of the projector off and unplug the power cord 3. Loosen the screws on the lamp case with a coin or screw driver4. Lift up the handle and pull out the lamp 8. Position the lamp cover you took off in step 7. Tighten the lamp case you took off in stepTROUBLESHOOTING When the Power Led Indicator does not light up Problem With The ProjectorWhen the Projector Lamp does not light up The Power Indicator remains redProblems With The Image Or Sound The Power Indicator is blinking redNo image appears on the screen Abnormal Image Coloring The words ‘No Signal’ appear on the screenNo response with remote control No SoundUnstable Image Displayed by VHS Video Player TECHNICAL SPECIFICATIONSGeneral OpticalProjector lamp Mechanical with lens and feet ElectricalEnvironmental Resize Display Supported Monitor DisplaysSupport Modes Computer In and Monitor Connector Pin Assignments