Microtek CX4 manual Connecting To An External Speaker, Speaker or PA, Data Projector

Page 23

Connecting To An External Speaker

Connecting To An External Speaker

Though the internal speakers of the projector are enough for most small size or medium-size rooms, an external speaker can be connected to achieve the best results for large room presentations.

The Steps of connecting the projector to an External Speaker:

1.Check to ensure that both the projector and all sources are turned off.

2.Connect the 3.5 mm stereo mini-plug of the Audio Cable to the Audio Out jack of the projector.

3.Connect the other end of the Audio Cable to the external speaker. Be sure to connect the white RCA plug to the left channel, the red RCA plug to the right channel.

Speaker or PA

L R

AUDIO

Data Projector

Audio Cable

22

Image 23

Contents Page INTRODUCTION Safety Instructions If the power cable or plug is damaged or frays Where To Get Help Transporting Your Projector Remote Control InformationWarning： Remote Control Briefing FunctionsINSTALLATION Unpacking The Projector Setting Up The Projector Do not mix used and new batteries Connecting To A Desktop Computer Connecting To A Computer5. Remove the computer mouse cable 8. Tighten all connector screws to ensure secure connections4. Connect the Control Cable to the Control port of the projector Data Projector Connecting To A NotebookDVI Source Connecting To A Macintosh Desktop Computer Connecting To A Macintosh PowerBook Connecting To A Set-top Box Connecting To A Video Source The steps of connecting the projector to the video source Page Connection of an audio cable from a computer source Connecting To An Audio SourceConnection of an audio cable from a video audio source Data Projector Connecting To An External SpeakerSpeaker or PA THIS PROJECTOR HOW TO OPERATETurning The Equipment On And Off Page The Focus and Zoom Functions How To Adjust The Projected ImageThe Resize key The Auto KeyHow To Operate This Projector like The Buttons on the Operation Panel of the Projector & Their FunctionsButtons FunctionsNote The ZOOM & FOCUS functions are not suitable to this model The Buttons on the Remote Control & Their FunctionsThe life of the lamp has ended, please replace with Examine The Projector StatusThe life of the lamp will soon end, please prepare a USING THE OSD MENU Brightness How To Access The OSD MenuHow To Change OSD Settings OSD MenuImage Black LevelContrast PositionMiscellaneous Auto ConfigurationInformation Save Input SelectVideo Mouse VolumeKeystone Projection ModeLanguage MAINTENANCE The Steps of Cleaning the Air Filter Cleaning the LensCleaning the Projector Case Cleaning the Air FilterThe Steps of Replacing a Lamp Replacing The Projector Lamp4. Lift up the handle and pull out the lamp 1. Turn the power of the projector off and unplug the power cord3. Loosen the screws on the lamp case with a coin or screw driver 8. Position the lamp cover you took off in step 7. Tighten the lamp case you took off in stepTROUBLESHOOTING The Power Indicator remains red Problem With The ProjectorWhen the Power Led Indicator does not light up When the Projector Lamp does not light upNo image appears on the screen Problems With The Image Or SoundThe Power Indicator is blinking red Abnormal Image Coloring The words ‘No Signal’ appear on the screenUnstable Image Displayed by VHS Video Player No response with remote controlNo Sound TECHNICAL SPECIFICATIONSProjector lamp GeneralOptical Environmental Mechanical with lens and feetElectrical Resize Display Supported Monitor DisplaysSupport Modes Computer In and Monitor Connector Pin Assignments