Microtek CX4 manual Connection of an audio cable from a video audio source

Page 22

Connection of an audio cable from a video audio source

Connection of an audio cable from a video audio source

1.Shut off the projector and video source if they are on.

2.Connect one end of the RCA Cable (Audio) to the Audio In jacks on the projector. Insert the white plug into the L Audio In jack and the red plug into the R Audio In jack.

3.Connect the other end of the RCA Cable (Audio) to the Audio Output jacks on the video audio source. Connect the white plug to the left channel and the red plug to the right channel.

21

Image 22

Contents Page INTRODUCTION Safety Instructions If the power cable or plug is damaged or frays Where To Get Help Remote Control Information Transporting Your ProjectorRemote Control Briefing Functions Warning：INSTALLATION Unpacking The Projector Setting Up The Projector Do not mix used and new batteries Connecting To A Computer Connecting To A Desktop Computer4. Connect the Control Cable to the Control port of the projector 8. Tighten all connector screws to ensure secure connections5. Remove the computer mouse cable DVI Source Connecting To A NotebookData Projector Connecting To A Macintosh Desktop Computer Connecting To A Macintosh PowerBook Connecting To A Set-top Box Connecting To A Video Source The steps of connecting the projector to the video source Page Connecting To An Audio Source Connection of an audio cable from a computer sourceConnection of an audio cable from a video audio source Speaker or PA Connecting To An External SpeakerData Projector HOW TO OPERATE THIS PROJECTORTurning The Equipment On And Off Page How To Adjust The Projected Image The Focus and Zoom FunctionsThe Auto Key The Resize keyHow To Operate This Projector Functions The Buttons on the Operation Panel of the Projector & Their FunctionsButtons likeThe Buttons on the Remote Control & Their Functions Note The ZOOM & FOCUS functions are not suitable to this modelThe life of the lamp will soon end, please prepare a Examine The Projector StatusThe life of the lamp has ended, please replace with USING THE OSD MENU OSD Menu How To Access The OSD MenuHow To Change OSD Settings BrightnessPosition Black LevelContrast ImageInformation Auto ConfigurationMiscellaneous Video Input SelectSave Projection Mode VolumeKeystone MouseLanguage MAINTENANCE Cleaning the Air Filter Cleaning the LensCleaning the Projector Case The Steps of Cleaning the Air FilterReplacing The Projector Lamp The Steps of Replacing a Lamp3. Loosen the screws on the lamp case with a coin or screw driver 1. Turn the power of the projector off and unplug the power cord4. Lift up the handle and pull out the lamp 7. Tighten the lamp case you took off in step 8. Position the lamp cover you took off in stepTROUBLESHOOTING When the Projector Lamp does not light up Problem With The ProjectorWhen the Power Led Indicator does not light up The Power Indicator remains redThe Power Indicator is blinking red Problems With The Image Or SoundNo image appears on the screen The words ‘No Signal’ appear on the screen Abnormal Image ColoringNo Sound No response with remote controlUnstable Image Displayed by VHS Video Player SPECIFICATIONS TECHNICALOptical GeneralProjector lamp Electrical Mechanical with lens and feetEnvironmental Supported Monitor Displays Resize DisplaySupport Modes Computer In and Monitor Connector Pin Assignments