OTC Wireless WiSER2400.IP, WiSER2400.Plus Password Protection, WiSER2400 Password Utility panel

Page 20

3.2 Password Protection

Before any change/modification can be made to the configuration of a WiSER2400, a password must be submitted before the configuration command is executed.

After entering the password, click “OK” to proceed “Cancel” to stop.

The Password Utility is also used to add or change a password for a

WiSER2400 unit.

Fig. 12 WiSER2400 Password Utility panel

NOTE: The default password of WiSER2400 is none. (Leave the field blank).

WiSER 2400 Technical Manual

Version 2.16

Copyright  2001-2005, OTC Wireless, Inc. All Rights Reserved

Page 20 of 32

Image 20

Contents Technical Manual Technical Manual Table of Contents Introduction Key Features Specifications Input PowerSerial Connections PowerStandard Hardware Selecting the Serial Mode for WiSER2400.Plus Status LEDsGround Installation System RequirementsUsing the WiSER2400 in a Point-to-point Link Using the WiSER2400 in a point-to-point link SchemePage Using the WiSER2400 in a point-to-point link Scheme Page Using the WiSER2400 in a Point-to-multiple point Link Using the WiSER2400 in a point-to-multiple Point linkPage Using the WiSER2400 in a point-to-multiple Point link Page Overview TabsDefaults Baud Rate 9600 / Data bits 8 / Parity none Password Protection WiSER2400 Password Utility panelWiSER2400 administration software Link Status panel Link StatusConfiguration Default value 9600 bps Serial PortSerial-IP-Proxy UDPWireless Port SsidPeer Host WEP Keys Creation EncryptionEncryption Wlan Statistics Statistics1 RS232 Statistics Admin Default password none leave blankTroubleshooting AppendixLimited Warranty Recovering from the Data Only ModeRegulatory Compliance FCC ID MKZ0207232XG