OTC Wireless WiSER2400.IP, WiSER2400.Plus technical manual Peer Host

Page 26

3.4.4 Peer Host

Destination Unit

MAC Address: The MAC address of the destination device.

IP Address: The destination IP address of the device that the WiSER2400 radio is set to communicate with. For TCP server and UDP modes, the IP Address can be left as

0.0.0.0.In TCP client mode, a valid IP address is

required.

Listen Port: The port number the destination device listens on to receive the TCP/UDP packets.

Note: The Peer Host is normally the computer on which the serial device’s application program is run.

Fig. 17 WiSER2400 administration software

Configuration/Peer Host panel

WiSER 2400 Technical Manual

Version 2.16

Copyright  2001-2005, OTC Wireless, Inc. All Rights Reserved

Page 26 of 32

Image 26

Contents Technical Manual Technical Manual Table of Contents Introduction Key Features Specifications Input PowerSerial Connections PowerStandard Hardware Selecting the Serial Mode for WiSER2400.Plus Status LEDsGround Installation System RequirementsUsing the WiSER2400 in a Point-to-point Link Using the WiSER2400 in a point-to-point link SchemePage Using the WiSER2400 in a point-to-point link Scheme Page Using the WiSER2400 in a Point-to-multiple point Link Using the WiSER2400 in a point-to-multiple Point linkPage Using the WiSER2400 in a point-to-multiple Point link Page Overview TabsDefaults Baud Rate 9600 / Data bits 8 / Parity none Password Protection WiSER2400 Password Utility panelWiSER2400 administration software Link Status panel Link StatusConfiguration Default value 9600 bps Serial PortSerial-IP-Proxy UDPWireless Port SsidPeer Host WEP Keys Creation EncryptionEncryption Wlan Statistics Statistics1 RS232 Statistics Admin Default password none leave blankTroubleshooting AppendixLimited Warranty Recovering from the Data Only ModeRegulatory Compliance FCC ID MKZ0207232XG