Onkyo TX-SR604/604E Correcting Sound and Picture Sync, Changing the Remote Controller’s ID

Advanced Setup—Continued

Correcting Sound and Picture Sync

When using progressive scanning on your DVD player, you may find that the picture and sound are out of sync. With this setting, you can correct this by delaying the audio signals. You can set it from 0 to 100 milliseconds (ms) in 10 millisecond steps.

ON/STANDBY	REMOTE MODE
	ZONE2

			RECEIVER	DVD	RECEIVER
			TAPE
	INPUT SELECTOR			M D/CDR
INPUT	1	2	3	CD
	V1	V2	V3	HDD
SELECTOR
	4	5	6	T V
	V4 MULTI CH		DVD
	7	8	9	VCR
	TAPE	TUNER	CD	CABLE
	10	11	12
	+10	0	CLR	SAT
	D TUN	ENT
	--/---	DIMMER	SLEEP
	TV	VOL	CH	VOL
			DISC
			ALBUM
	INPUT
	GUIDE			PREVIOUS
	TOP MENU			MENU
				MUTING
		ENTER
	PLAYLIST/CAT		PLAYLIST/CAT
	RETURN			SETUP

1	Press the [RECEIVER] button.
	RECEIVER

Changing the Remote Controller’s ID

If several Onkyo components are used in the same room, the remote controller’s control codes may overlap with those of another component. To differentiate the remote controller’s control codes, you can change its ID to another number.

Note:

If you change the remote controller’s ID, be sure to set the same ID on both the remote controller and AV receiver (see “Changing the AV Receiver’s ID” on page 76). The default ID for both is 1.

TV		VOL	CH		VOL
			DISC
			ALBUM
INPUT
GUIDE					PREVIOUS
TOP MENU		ZONE2	REMOTE MODEMENU
ON/STANDBY
			RECEIVER		DVD	RECEIVER
			TAPE		MUTING
INPUT SELECTOR					M D/CDR	Number
1		2 ENTER 3			CD
					HDD	buttons
V1		V2	V3
PLAYLIST/CAT				PLAYLIST/CAT
4		5	6		TV
V4	MULTI CH		DVD
RETURN					SETUP
7		8	9		VCR
TAPE		TUNER	CD	12	CABLE
10		11
		LISTENING MODE
STEREO		SURROUND
AUDIO SUBTITLE RANDOM					REPEAT
TEST TONE		CH SEL	LEVEL-		LEVEL+
PLAY MODE						CINE FLTR
DISPLAY			L NIGHT		CINE FLTR
		VCR	DVD		HDD
		RC-651M

2

1 2 3

V1 V2 V3

46

V4DVD

Press and hold, for more than 4 seconds, the input selector but- ton for the input source that you want to correct.

This can be the [DVD], [VIDEO 1], [VIDEO 2], [VIDEO 3] or [VIDEO 4] input source.

1	Press the [RECEIVER] and the [CINE
	FLTR] at the same time.
	The [RECEIVER] button lights up.
2	Use the number buttons to enter a remote
	control ID.

3 Use the Left and Right []/[ ] buttons to adjust the delay from 0 to 100 milliseconds in 10 milli- second steps.

Note:

This setting is not available when the Pure Audio listen- ing mode is used, or the Direct listening mode is used with an analog input signal.

You can enter 1, 2, or 3.

78