Onkyo TX-SR502E instruction manual Connecting Antenna, Connecting an Outdoor FM Antenna

Page 19

TX-SR502_En.book Page 19 Tuesday, February 17, 2004 12:14 PM

Connecting Antenna—Continued

Connecting an Outdoor FM Antenna

If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available out- door FM antenna instead.

FM 75

Notes:

Outdoor FM antennas work best outside, but usable results can sometimes be obtained when installed in an attic or loft.

For best results, install the outdoor FM antenna well away from tall buildings, preferably with a clear line of sight to the transmitter.

Outdoor antenna should be located away from possi- ble noise sources, such as neon signs, busy roads, etc.

For safety reasons, outdoor antenna should be situated well away from power lines and other high-voltage equipment.

Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock haz- ards.

Using the 75/300-ohm Antenna Adapter

The 75/300-ohm Antenna Adapter is not supplied with American and European models.

The 75/300-ohm antenna adapter can be used to connect an FM antenna using either 75-ohm coaxial cable or 300-ohm twin-core flat cable.

Connecting 300-ohm Flat Cable

3

Move the small wire inside the adapter

 

from position A to position B, as shown.

 

Position A

 

Wire

 

Position B

4

Insert the central conductor (1), as

 

shown, and use a small pair of pliers to

clamp the shielding and outer insulation sections of the cable (2), as shown.

1

2

Make sure the shielding is not touching the central conductor.

5 Refit the adapter’s cover, and then plug the adapter into the 75 socket.

Using a TV/FM Antenna Splitter

It’s best not to use the same antenna for both FM and TV reception, as this can cause interference problems. If cir- cumstances demand it, use a TV/FM antenna splitter, as shown.

TV/FM antenna splitter

1

Using a screwdriver, loosen the

 

two screws on the adapter, wrap

 

the bare wires around the

 

screws, and then retighten them,

 

as shown.

2

Plug the adapter into the 75 socket.

To AV receiver

To TV (or VCR)

Connecting an Outdoor AM Antenna

If good reception cannot be achieved using the supplied AM loop antenna, an outdoor AM antenna can be used in addition to the loop antenna, as shown.

Outdoor antenna

Connecting 75-ohm Coaxial Cable

1

Strip and prepare the

 

 

 

 

 

 

 

 

 

 

 

 

 

15 mm

 

 

 

75 ohm coaxial cable,

 

 

 

mm mm mm

 

 

 

 

 

6

3

 

6

 

 

 

 

as shown.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1/4"

 

1/8"

1/4"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5/8"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

Using your fingernails or a small screw-

 

driver, lever the adapter’s tabs outward

 

 

 

 

and remove the cover, as shown.

Insulated antenna cable

AM loop antenna

ANTENNA

AM

Outdoor AM antennas work best when installed horizon- tally outside, but good results can sometimes be obtained indoors by mounting horizontally above a window. Note that the AM loop antenna should be left connected.

Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock hazards.

19

Image 19
Contents TX-SR502 TX-SR502E Avis Important Safety InstructionsPower PrecautionsIf in any doubt, consult a qualified electrician Precautions Supplied AccessoriesFCC Information for User Table of Contents FeaturesFront Panel Front & Rear PanelsDisplay Front & Rear PanelsVideo 3 Input Subwoofer PRE OUT Rear PanelFront Speakers B AC OutletInstalling the Batteries Before Using the TX-SR502/TX-SR502EUsing the Remote Controller AMP Tuner Remote ControllerHow to Use the Remote Controller AMP/TUNER ModeRemote Controller DVD DVD ModeCD Mode Tape MD Mode & CDR ModeCDR TV CH Tape ModeTV Control Buttons TV InputEnjoying Home Theater Connecting Your SpeakersSpeaker Configuration Attaching the Speaker Labels Connecting Your SpeakersConnecting Your Speakers Connecting the Speaker CablesConnecting the AM Loop Antenna Connecting AntennaConnecting Antenna Connecting the Indoor FM AntennaConnecting an Outdoor FM Antenna Connecting AntennaConnecting an Outdoor AM Antenna Optical Digital Inputs Connecting the TX-SR502/TX-SR502EBefore Making Any Connections AV Cables & SocketsVideo Connection Formats Connecting the TX-SR502/TX-SR502EConnection Guide Which Connections Should I Use?Monitor Out Audio Connections Connecting Your TV or ProjectorYour TV must also be connected via component video Connecting a DVD playerUsing Analog Connections Video ConnectionsDVD Multichannel Connection Connecting a VCR for PlaybackVCR Connecting a VCR for Recording Connecting a D-VHS VCR for PlaybackVideo Connections Audio Connections Satellite, cable, set-top box LD player, etc Camcorder, games console, etc Connecting a Camcorder, Games Console, etcCamcorder Games console, etc OtherCD player DAT, CD, or MiniDisc recorder Connecting a CD Player Connecting a Cassette RecorderCassette recorder CD playerDAT, CD, or MiniDisc recorder Phono preamp Connecting a TurntableUsing a Coaxial or Optical Connection playback only Turntable without a Built-in Phono PreampConnecting the Power Cords of Other Components Connecting Onkyo ComponentsConnecting the Power Cord Turning On First Time Setup Speaker Configuration First Time SetupButton so that Tape appears Press the Setup buttonChanging the TAPE/MD/CDR Display Press the Tape input selectorSelecting the Source Component Playing Your AV ComponentsBy the Multi CH button so that Using the Multichannel InputPlaying Your AV Components Displaying Source InformationListening to the Radio Using the TunerTuning into Radio Stations Setting the AM Tuning Interval Worldwide model onlyDeleting Presets Using the TunerPresetting Radio Stations Selecting Preset StationsAdjusting the Bass & Treble Setting the Display BrightnessCommon Functions Common Functions Using the Sleep TimerAdjusting Speaker Levels Temporarily Using HeadphonesDTS-ES Using the Listening ModesSelecting on the TX-SR502/TX-SR502E Using the Listening ModesSelecting with the Remote Controller Selecting Listening ModesSurround Modes Use this mode with video games that feature stereo soundAbout the Listing Modes Basic ModesOnkyo Original DSP Modes Listening mode indicatorsDTS-ES Dolby Digital/DTS setting 5.1 or 6.1-channel playback Recording the Input Source RecordingRecording from Different AV Sources Adjusting the DTS Neo6 Music Mode Using the Audio Adjust FunctionsAdvanced Function Adjusting the PL II or PL IIx Music Mode Digital Input Signal FormatsAdvanced Function Crossover Frequency Advanced SetupSpeaker Distance Speaker Levels Advanced SetupControlling Other Components Entering Remote Control CodesResetting the DVD, CD, MD or CDR Mode Button Resetting the Remote ControllerSAT satellite receiver Remote Control CodesControlling Other Components DVD DVD playerABC CBL cable receiverTX-SR502En.book Page 53 Tuesday, February 17, 2004 1214 PM TX-SR502En.book Page 54 Tuesday, February 17, 2004 1214 PM Controlling a Satellite Receiver Controlling a TVControlling a Cable Receiver Controlling a VCRTroubleshooting TV? TroubleshootingTuner presets no Tuner Recording Others Symptom Possible cause RemedyREO indicator flashes? Signals?Video Section SpecificationsAmplifier Section GeneralOnkyo Europe Electronics GmbH Onkyo U.S.A. CorporationOnkyo China Limited
Related manuals
Manual 60 pages 60.03 Kb