Onkyo TX-SR502 Changing the TAPE/MD/CDR Display, Press the Setup button, On the display

TX-SR502_En.book Page 33 Tuesday, February 17, 2004 12:14 PM

First Time Setup—Continued

7

ENTER

ENTER

Use the Down [	] button to
select “Surr Back,” and use the
Left and Right [	]/[ ] buttons to

select Small, Large, or None.

Small: Select if the surround back speaker is small.

Large: Select if the surround back speaker is large.

None: Select if no surround back speaker is connected.

Notes:

•If the Surround setting in step 6 is set to None, this setting does not appear.

•If the Surround setting in step 6 is set to Small, the Large option cannot be selected.

Changing the TAPE/MD/CDR Display

If you connect an -compatible Onkyo MiniDisc recorder or CD recorder to the TAPE IN/OUT sockets,

for to work properly, you must change this setting. This setting can only be changed on the TX-SR502/ TX-SR502E.

										MASTER VOLUME
STANDBY/ON									TUNING
									PRESET
	STANDBY
								SETUP	RETURN
A SPEAKERS B	TONE	STEREO	LISTENING	DISPLAY	DIGITAL INPUT	MEMORY	TUNING MODE
			MODE
PHONES										VIDEO 3 INPUT
	MULTI CH	DVD	VIDEO 1	VIDEO 2	VIDEO 3	TAPE	TUNER	C D	S VIDEO	VIDEO	L AUDIO R
			VCR

TAPE

8	Press the [SETUP] button.
	Setup closes.

1	Press the [TAPE] input selector
TAPE	button so that “TAPE” appears
	on the display.

To test that all of your speakers are working properly,	2
press the remote controller’s [TEST TONE] button.	TAPE
The test tone will be output by each speaker in turn
and the name of each speaker will appear on the dis-
play. To turn off the test tone, press the [TEST
TONE] button again.

•If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display, you may have wired your speakers incorrectly and you should check your connections (see page 17).

•If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the speaker settings incorrectly (see page 32).

Press and hold down the [TAPE] input selector button (about 3 seconds) to set the display.

Repeat this step to select TAPE, MD, or CDR.

33