Onkyo TX-SR502E instruction manual Front & Rear Panels, Front Panel

TX-SR502_En.book Page 6 Tuesday, February 17, 2004 12:14 PM

Front & Rear Panels

Front Panel

American Model

B

C 5 G H I J K L M N

MASTER VOLUME

STANDBY/ON

TUNING

ENTER

PRESET

STANDBY

SETUP

RETURN

A SPEAKERS B

TONE

STEREO

LISTENING

DISPLAY

DIGITAL INPUT

MEMORY

TUNING MODE

MODE

CLEAR

PHONES

VIDEO 3 INPUT

MULTI CH

DVD

VIDEO 1

VIDEO 2

VIDEO 3

TAPE

TUNER

C D

S VIDEO

VIDEO

L

AUDIO

R

VCR

O

P

Q

R

S

T U V W

X

Other Models
A		D 6
						MASTER VOLUME
STANDBY/ON						TUNING
					ENTER	PRESET
		PURE AUDIO
POWER		STANDBY
					SETUP	RETURN
ON OFF
A SPEAKERS B	TONE	PURE AUDIO	LISTENING	DISPLAY DIGITAL INPUT	MEMORY TUNING MODE
			MODE
					CLEAR

For detailed information, refer to the pages in parenthesis.

APOWER switch (31)

The American model doesn’t have this switch. This is the main power switch. When set to OFF, the TX-SR502/TX-SR502E is completely shutdown. When set to ON, the TX-SR502/TX-SR502E is in Standby mode and the STANDBY indicator lights up.

Don’t turn on the power until you’ve completed, and double-checked all connections (pages 17–30).

BSTANDBY/ON button (31)

This button is used to set the TX-SR502/ TX-SR502E to On or Standby. For models with a POWER switch, this button has no effect unless the POWER switch is set to ON.

CSTANDBY indicator (31)

This indicator lights up when the TX-SR502/ TX-SR502E is in Standby mode, and it flashes while a signal is being received from the remote controller.

DPURE AUDIO indicator (41)

The American model doesn’t have this indicator. This indicator lights up when the Pure Audio listen- ing mode is selected. (No video signals are output in this mode.)

ESTEREO button (41)

This button is used to select the Stereo listening mode. (American model only)

FPURE AUDIO button (41)

The American model doesn’t have this button. This button is used to select the Pure Audio listen- ing mode.

G LISTENING MODE [] [ ] buttons (41)

These buttons are used to select the listening modes.

HDISPLAY button (35)

This button is used to display various information about the currently selected source.

IDIGITAL INPUT button (31, 47)

This button is used to assign the digital inputs and to specify the format of digital input signals.

JDisplay

6