Onkyo TX-SR502E instruction manual First Time Setup, Speaker Configuration

TX-SR502_En.book Page 32 Tuesday, February 17, 2004 12:14 PM

First Time Setup—Continued

Speaker Configuration

This section explains how to specify which speakers are connected and their sizes.

For speakers with a cone diameter larger than 6-1/2 inches (16 cm), specify Large. For those with a smaller diameter, specify Small.

					Cone diameter
	ON	STANDBY		TV
			I	INPUT
	V1	V2	V3
	1	2	3	+
	DVD	MULTI CH		TV CH
	4	5	6	-
	CD	TAPE	TUNER
	7	8	9
				TV VOL
	+10	0	CLEAR
	--/---			TUNER/
	TONE	_		TAPE	AMP
			+	AMP
		REMOTE MODE
	DVD	CD	MD	CDR
	TV	VCR	CABLE	SAT
	DIMMER			SLEEP
	TV	U	MEN
		PMEN
ENTER	INPUT	TO	U
	+
	CH

3	While the Subwoofer setting is
	selected, use the Left and Right
ENTER	[ ]/[ ] buttons to select Yes or
	No.
	Yes: Select if a subwoofer is con-
	nected.
	No: Select if no subwoofer is con-
	nected.
4	Use the Down [	] button to
	select “Front,” and then use the
ENTER	Left and Right [	]/[ ] buttons to
	select Small or Large.

Small: Select if the front speakers are small.

Large: Select if the front speakers are large.

ENTER

Note:

• If the Subwoofer setting in step 3 is set to No, this setting is fixed at Large and does not appear.

DISC		ENTER		VOL
-		EXIT
			E	SETUP
	RET		GUID
PREV		URN	TUP
CH			SE
DISPLAY				MUTING
REC	SP A		SP B	RANDOM
AUDIO	SUBTITLE		ANGLE	LAST M
SURR	ALL ST			STEREO
REPEAT	A-B		SEARCH	MEMORY
	DIRECT		DSP	DSP

1 AMP Press the [AMP] button followed

by the [SETUP] button.

5

ENTER

ENTER

Use the Down[ ] button to select “Center,” and then use the Left and Right [ ]/[ ] buttons to select Small, Large, or None.

Small: Select if the center speaker is small.

Large: Select if the center speaker is large.

None: Select if no center speaker is connected.

Note:

•If the Front setting in step 4 is set to Small, the Large option cannot be selected.

2	Use the Up and Down [ ]/[ ]
	buttons to select “1. SP Config,”
ENTER	and then press the [ENTER] but-
	ton.

ENTER

6

ENTER

ENTER

Use the Down[ ] button to select “Surround,” and then use the Left and Right [ ]/[ ] but- tons to select Small, Large, or None.

Small: Select if the surround left and right speakers are small.

Large: Select if the surround left and right speakers are large.

None: Select if no surround left and right speakers are connected.

Note:

•If the Front setting in step 4 is set to Small, the Large option cannot be selected.

32