Onkyo TX-SR502E instruction manual Advanced Setup, Speaker Levels

TX-SR502_En.book Page 49 Tuesday, February 17, 2004 12:14 PM

Advanced Setup—Continued

5 Use the Left and Right []/[ ] buttons to specify the distance for “Front,” then press the Down

ENTER

[ ] button to select the next speaker.

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “3. Level Cal,” and then press the [ENTER] but- ton.

A pink noise test tone is output by the front left speaker.

6	Repeat step 5 for all speakers.
	Note:
	Speakers that you set to No or None in
	the Speaker Configuration (page 32)
	cannot be selected.
7	Press the [SETUP] button.
	Setup closes.

Notes:

3	Turn up the volume so that you
	can hear the test tone suffi-
	ciently.
	While each speaker outputs the test
	tone, its name appears on the display, as
	shown.

•The Center and Subwoofer distances can be set up to 5 ft. (1.5 m) more or less than the Front distance. For example, if the Front distance is set to 20 ft. (6 m), the Center and Subwoofer distances can be set between 15 and 25 ft. (4.5 and 7.5 m).

•The SurrRight, Surr Left, and Surr Back distances can be set up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the Front distance. For example, if the Front dis- tance is set to 20 ft. (6 m), the SurrRight, Surr Left, and Surr Back distances can be set between 5 and 25 ft. (1.5 and 7.5 m).

4

ENTER

ENTER

Use the Left and Right [	]/[ ]
buttons to adjust the speaker
level, and use the Down [	] but-

ton to select the next speaker.

The level can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).

Speaker Levels

With this function you can adjust the volume of each speaker so that all speakers can be heard equally at the listening position.

Speaker levels cannot be set while the TX-SR502/TX-SR502E is muted.

1 AMP Press the [AMP] button followed

by the [SETUP] button on the remote controller.

5	Repeat step 4 so that the level of
	the test tone from each speaker
	is the same.
	Speakers that you set to No or None in
	the Speaker Configuration (page 32) do
	not output the test tone.
6	Press the [SETUP] button.
	Setup closes.
	Don’t forget to turn down the volume if
	you turned it up while setting the levels.

Notes:

•This procedure can also be performed by using the remote controller. First press the [TEST TONE] but- ton to output the test tone. Use the [LEVEL–] and [LEVEL+] buttons to adjust the levels, and use the [CH SEL] button to select the speakers.

49