Network Setting Up
This projector provides the NETWORK function. When you start to use this function, please consult your dealer for further information.
To start, connect the network port to a gateway device via a
When your Network enables the DHCP function
The IP Address can be set automatically if the DHCP is "TURN ON" using the NETWORK menu. Please refer to the section "NETWORK Menu".
When your Network doesn’t support the DHCP function
or When you use a fixed address even if your Network can support the DHCP function
Please set the IP Address, the Subnet Mask, the Default Gateway and the DHCP using the NETWORK menu.(Page 35) At first, set the DHCP function to “TURN OFF”.
You can set them using a Web Browser (Internet Explore 4.0 or higher) on the computer connected to the Network.
Input the same IP address as set to the projector onto the Web Browser on the computer connected to LAN.
ex. Case of IP Address = 192.168.1.11
1)Input “http://192.168.1.11”.
2)Click “ENTER”.
3)Input the required data according to the screen.
4)Make sure the input data is correct, then click "Write".
memo These setting will be active after reboot. These setting will be stored, and used when DHCP is OFF.
5)Click “Return to top page”.
6)Click “REBOOT” to complete this operation.
36 | © 3M 2004 3M™ Multimedia Projector X70/X80 |