Using as a wired Remote Control

Installing the Projector

Effective Range and Distance of the Remote Control Unit

The operable distance of the remote control unit is about 7m for direct reception. The remote control unit can be used by having the transmission signals reflected by the screen. In this case, please set the total distance (distance between projector and screen,

Aand distance between remote control, B) of “A + B” within 7m. The operable angles of the remote control unit are 30˚ right and left, and 20˚ up and down.

Using as a wireless remote control unit

As the effect of signals reflected from the remote control unit differ with the type of screen used, effective range and distance may decrease.

Screen

30˚

30˚ Remote Control Sensor (rear)

Aim the remote control unit towards the remote sen- sor on the front or rear of the projector. The operable distance of the remote control unit is about 7m for di- rect reception. If the remote control fails to work prop- erly, move closer to the projector.

20˚		Projector	Projector
20˚
20˚	A		30˚
20˚			30˚
B			30˚
			20˚
			20˚
Remote Control			Remote Control
Unit			Unit

By connecting a separately sold remote control (RM-M3010) and cable (about 3m: QAM0081-001/ 15m: QAM0247-001) to the REMOTE terminal, the remote control can be used as a wired control unit. When connected to the cable, the remote control’s transmitter and the projector’s sensor would not function. Please keep within the range of the remote cable length. Warranty is not extended to the case where an extension cord is used.

❈The ESCAPE button on the separately sold remote control (RM-M3010) is equivalent to the EXIT button on the supplied remote control unit. There is no equivalent to the H, V-KEYSTONE and FOCUS buttons found on the supplied remote control.

QUICK

ALIGN.OPERATE

PC VIDEO

HIDE

DIGITAL VOLUME FREEZE ZOOM

PRESETMENU

REMOTE	RS-232C OUT
	CONTROL

Remote control	Projector
(sold separately)
	Remote Cable
	(sold separately)

Again, when a remote cable is connected to the REMOTE terminal of the projector, the sensor would not work. Check to see if the cable is connected. When a remote cable is connected to the remote control terminal, the transmitter would not work.

ESCAPEENTER

When the remote control unit fails to work properly

•When the batteries in the remote control unit are exhausted, improper functioning would occur. Please replace with new batteries.

•When either the remote control unit or projector alone is connected to the remote cable, the connected side will not be able to work. Please check the cable connection.