Onkyo 29344937, HT-S6200 Speaker Settings, Buttons to select Sp Type, Use the Left and Right e/ r

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the Audyssey 2EQ™ Room Correction and Speaker Setup again (see page 46).

If the impedance of any speaker is 4 ohms or more but less than 6, set the Speaker Impedance to 4 ohms.

North American models do not support speakers with an impedance of less than 6 ohms.

To use bi-amping, you must change the Speaker Type setting. For hookup information, see page 22.

Notes:

•When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room.

•Before you change these settings, turn down the volume.

1Press the [RECEIVER] button, followed by the [SETUP] button.

2	Use the Up and Down [q]/[w]
	buttons to select “2. Speaker

Setup”, and then press [ENTER].

3 Use the Up and Down [q]/[w] buttons to select “2-1. Sp Settings”, and then press [ENTER].

4	(Asian models) Use the Up and
	Down [q]/[w] buttons to select
	“Impedance”, and use the Left
	and Right [e]/[r] buttons to
	select:
	4 ohms: Select if the impedance of any
	speaker is 4 ohms or more but
	less than 6.
	6 ohms: Select if the impedances of all
	speakers are between 6 and
	16 ohms.
5	Use the Up and Down [q]/[w]
	buttons to select “Sp Type”, and
	use the Left and Right [e]/[r]
	buttons to select:
	Normal: Select this if you’ve
	connected your front speakers
	normally.
	Bi-Amp:Select this if you’ve
	connected your front speakers
	for bi-amped operation.
	Note:
	Powered Zone2 cannot be used if “Sp
	Type” is set to “Bi-Amp”.
6	Use the Up and Down [q]/[w] but-

tons to select “SB/FH”, and then use the Left and Right [e]/[r] buttons to select:

FrontHigh:

Select this if you’ve con- nected your front high speak- ers to the SURR BACK L/R terminal posts.

SurrBack:

Select this if you’ve con- nected your surround back speakers to the SURR BACK L/R terminal posts.

	Note:
	If the “Sp Type” setting is set to “Bi-
	Amp”, or Powered Zone 2 is set to “Not
	Act” (page 81), this setting cannot be
	selected.
7	Press the [SETUP] button.
	Setup closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

44