Onkyo HT-S6200, 29344937 Connecting Antenna, Connecting the Indoor FM Antenna, Asian models

Page 23

Connecting the AV receiver—Continued

Connecting Antenna

This section explains how to connect the supplied indoor FM antenna and AM loop antenna, and how to connect commercially available outdoor FM and AM antennas. The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use the tuner.

AM ANTENNA push terminals

FM ANTENNA jack

Connecting the Indoor FM Antenna

The supplied indoor FM antenna is for indoor use only.

1 Attach the FM antenna, as shown.

■North American models

Insert the plug fully into the jack.

■Asian models

Insert the plug fully into the jack.

Once your AV receiver is ready for use, you’ll need to tune into an FM radio station and adjust the position of the FM antenna to achieve the best possible reception.

2 Use thumbtacks or something similar to fix the FM antenna into position.

Thumbtacks, etc.

Caution: Be careful that you don’t injure yourself when using thumbtacks.

If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead (see page 24).

Connecting the AM Loop Antenna

The supplied indoor AM loop antenna is for indoor use only.

1 Assemble the AM loop antenna, inserting the tabs into the base, as shown.

2 Connect both wires of the AM loop antenna to the AM push terminals, as shown.

(The antenna’s wires are not polarity sensitive, so they can be connected either way around.) Make sure that the wires are attached securely and that the push terminals are gripping the bare wires, not the insulation.

Push

Insert wire

Release

Once your AV receiver is ready for use, you’ll need to tune into an AM radio station and adjust the position of the AM antenna to achieve the best possible reception.

Keep the antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.

If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM antenna (see page 24).

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents HT-S6200 Avis Important Safety InstructionsBatteries and Heat Exposure Warning PrecautionsPower Preventing Hearing Loss CautionSpeaker Precautions Package Contents Package Contents Contents Connections FeaturesAmplifier ProcessingFeatures Zone 2 Room Multiroom CapabilityMain Room Front Panel Front & Rear PanelsDisplay Front & Rear PanelsRear Panel VCR/DVR IN/OUT Remote ControlTV/TAPE IN/OUT CBL/SATSubwoofer SKW-770 Speaker PackageSpeaker terminals Speaker PackageKeyhole slots Aiming the Remote Controller Remote ControllerInstalling the Batteries Controlling the AV receiver Remote ControllerEnjoying Home Theater About Home TheaterSpeaker Connection Precautions Connecting the AV receiverConnecting Your Speakers Speaker ConfigurationPush terminals Connecting the AV receiverConnecting the Speaker Cables Terminal postsWall Mounting Using the Rubber Stoppers for a More Stable PlatformUsing the Floor Pads for Subwoofer Bi-amping Speaker Hookup Bi-amping the Front SpeakersAttach the FM antenna, as shown North American models Connecting AntennaConnecting the Indoor FM Antenna Connecting the AM Loop AntennaUsing a TV/FM Antenna Splitter Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna AV Cables and Jacks About AV ConnectionsOptical Digital Jacks AV Connection Color Coding Audio Connection Formats Connecting Both Audio & VideoWhich Connections Should I Use? Video Connection FormatsAbout Copyright Protection Connecting Components with HdmiAbout Hdmi Supported Audio FormatsStep Video SignalsAudio Signals Making Hdmi ConnectionsAudio Connection Connecting a TV or ProjectorVideo Connection Connecting a DVD/BD Player Connecting a VCR or DVR for Playback Make the audio connection a Connecting a VCR or DVR for RecordingComponent Video in 2 CBL/SAT Make the video connection a Make the audio connection a Connecting a Camcorder, Game Console, or Other DeviceConnecting a Portable Audio player CD Player or Turntable MM with Built-in Phono Preamp Step Connecting a CD Player or TurntableConnecting a Cassette, CDR, MiniDisc, or DAT Recorder If Your iPod or iPhone Don’t Support Video Connecting an RI DockNot all iPod models output video If Your iPod or iPhone Supports VideoConnecting a Dock with the Universal Port connector Direct Change Connecting Onkyo u ComponentsConnecting the Power Cord Auto Power On/StandbyUp and Running in a Few Easy Steps Turning On the AV receiverTurning On and Standby Press the Setup button First Time SetupHdmi Input Setup Followed by the Setup buttonComponent Video Input Setup First Time SetupSetup closes Digital Input SetupUse the Up and Down q/ w but Speaker SettingsButtons to select Sp Type, Use the Left and Right e/ rChanging the Input Display Second measurement point Audyssey 2EQ Room Correction and Speaker SetupMeasurement Positions First measurement pointUsing Audyssey 2EQ Using a Powered Subwoofer Error MessagesTo Retry the Room Correction and Speaker Setup Changing the Speaker Settings ManuallyBasic AV receiver Operation Select a listening mode and enjoyBasic Operations Bass Adjusting the Bass & TrebleBasic Operations Displaying Source InformationUsing Headphones Setting the Display BrightnessMuting the AV receiver Using the Sleep Timer Auto default Using the Music OptimizerSpecifying the Digital Signal Format Use the Left and Right e/r AM/FM Frequency Step SetupListening to the Radio North American models Asian modelsListening to the Radio Using the TunerTuning into AM/FM Radio Stations Listening to the RadioDisplaying AM/FM Radio Information Tuning into Stations by FrequencySelecting Presets Presetting AM/FM StationsDeleting Presets Made for About the UP-A1 series DockCompatible iPod/iPhone models Putting Your iPod/iPhone in the DockControlling iPod/iPhone Using Your iPod or iPhone models Alarm ClockCharging Your iPod or iPhone models Battery UP-A1 series Dock for iPod/iPhoneStatus messages Recording Selecting on the AV receiver Using the Listening ModesSelecting with the Remote Controller Selecting Listening ModesMono/Multiplex Sources Using the Listening ModesListening Modes Available for Each Source Format Available Listening Modes Stereo SourceDTS/DTS-HD Channel SourcesDTS-ES DTS-ES Discrete/Matrix SourcesAbout the Listening Modes Onkyo Original DSP Modes Speaker Setup Advanced SetupCommon Procedures in Setup Menu Sp Distance Speaker Distance Advanced SetupUse the Down w button to select Ch, and then use the Left Equalizer Equalizer SettingsLeft and Right e/ r buttons to adjust the level at that Level Cal Speaker Levels CalibrationDolby EX Audio AdjustAudio Adjust Mux/Mono Multiplex/Mono DolbyAudyssey D Theater-DimensionalDTS Neo6 Music Using the Audio Settings Speaker Layout Audyssey Dynamic VolumeCinemaFILTER Music OptimizerAssigning Listening Modes to Input Sources Sync Source SetupIntelliVolume Volume Setup Miscellaneous Volume SetupTuner Hardware SetupRemote ID Hdmi Ctrl Power CtrlLipSync XvColorZone Connecting ZoneConnecting Your Zone 2 Speakers Directly to the AV receiver Connecting Your Zone 2 Speakers to an Amp in ZoneIf you’ve connected your Zone 2 speakers to the AV Setting the Powered ZoneSettings, and then press Enter Use the Up and Down q/wControlling Zone 2 from the AV receiver Using ZoneControlling Zone 2 with the Remote Controller Muting Zones Adjusting the Volume of ZonesControlling Other Components Preprogrammed Remote Control CodesEntering Remote Control Codes Controlling Other Components Remote Control Codes for Onkyo Components Connected via uResetting Remote Mode Buttons Resetting the Remote ControllerControlling a TV Controlling a DVD Player, or DVD Recorder Controlling a VCR or PVR Controlling a Satellite Receiver or Cable Receiver Disc +/- button Controlling a CD PlayerPlaylist e/r button When Using an RI DockControlling an RI Dock Reverse Play t button Controlling a Cassette RecorderPrevious and Next 7/6 buttons Rewind and Fast Forward 5/4 buttonsTroubleshooting Troubleshooting There’s no video Remote controller doesn’t workCan’t control other components There’s no soundU functions don’t work Sound changes when I connect my headphonesCan’t record How do I change the language of a multiplex sourceTuner Section SpecificationsAmplifier Section Video SectionCenter Speaker SKC-670 SpecificationsPowered Subwoofer SKW-770 Front Speaker SKF-670Memo 3 4 4 9 3

HT-S6200, 29344937 specifications

The Onkyo HT-S6200 is a versatile and powerful home theater system that delivers an impressive audio experience for music and movie enthusiasts alike. One of its standout features is the 7.1-channel surround sound configuration, which creates an immersive sound environment, enveloping listeners with crystal-clear audio. This configuration is especially effective in large rooms, providing an enveloping sound that enhances the viewing experience for everything from action-packed movies to nuanced dramas.

The system includes a powerful AV receiver, model TX-SR313, boasting a variety of connectivity options. With six HDMI inputs, it allows users to connect multiple devices such as Blu-ray players, gaming consoles, and streaming devices easily. The receiver supports 4K video pass-through, making it future-proof for high-definition content and ideal for users looking to enjoy the latest in home entertainment.

Another key aspect of the HT-S6200 is its implementation of Dolby TrueHD and DTS-HD Master Audio technologies. These formats deliver lossless audio, ensuring that soundtracks and sound effects are reproduced with stunning fidelity, replicating a cinema-like experience at home. Furthermore, the system features Dolby Pro Logic IIz, which enhances the surround sound experience by creating an additional layer of depth through front height channels.

The Onkyo HT-S6200 also integrates a user-friendly graphical user interface, making setup and operation straightforward. High-quality speaker components, including a powered subwoofer with a 12-inch driver, produce deep, powerful bass, providing an excellent anchor for the overall sound stage. The satellite speakers are designed to deliver clear midrange and high frequencies, ensuring every dialogue and musical note is distinct and engaging.

With its elegant design, the HT-S6200 fits seamlessly into any home décor, while also providing robust performance. The system also supports Onkyo’s exclusive AccuEQ room acoustic calibration technology, which automatically adjusts the sound settings to suit the specific acoustics of a room. This feature enhances the listening experience by optimizing audio playback according to the user’s environment.

In summary, the Onkyo HT-S6200 combines advanced audio technologies, versatile connectivity options, and user-friendly features to create a compelling home theater system. Whether enjoying a thrilling movie night or listening to music, this system promises to elevate any audio experience, making it a worthy investment for any home entertainment enthusiast.
Top Page Image Contents