Onkyo 29344937, HT-S6200 instruction manual Source Setup, IntelliVolume, Sync

Advanced Setup—Continued

Source Setup

This section explains items on the “Source Setup” menu. Items can be set individually for each input selector.

1	Press the input selector buttons to select
	an input source, and then press the
	[RECEIVER] button.
2	Press the [SETUP] button.
3	Use the Up and Down [q]/[w] buttons to
	select “4. Source Setup”, and then press
	[ENTER].
4	Use the Up and Down [q]/[w] buttons to
	select an item, and then press [ENTER].
5	Use the Left and Right [e]/[r] buttons to
	change it.
	The “Source Setup” menu items are explained
	below.
6	When you’ve finished, press the [SETUP]
	button.

Setup closes.

IntelliVolume

With IntelliVolume, you can set the input level for each input selector individually. This is useful if one of your source components is louder or quieter than the others. Use the Left and Right [e]/[r] buttons to set the level. If a component is noticeably louder than the others, use the Left [e] button to reduce its input level. If it’s notice- ably quieter, use the Right [r] button to increase its input level. The input level can be adjusted from −12 dB to +12 dB in 1 dB steps.

Note:

IntelliVolume does not apply for Zone 2.

A/V Sync

When using your DVD player’s progressive scanning function, you may find that the picture and sound are out of sync. With the A/V Sync setting, you can correct this by applying a delay to the audio signal.

The delay can be set from 0 to 100 milliseconds (msec) in 10 millisecond steps.

Use the Left and Right [e]/[r] buttons to set the delay. To view the TV picture while setting the delay.

If HDMI Lip Sync is “enabled” (see page 79), and your TV or display supports HDMI Lip Sync, the displayed delay time will be the A/V Sync delay time. The HDMI Lip Sync delay time is displayed underneath in parentheses.

Note:

A/V Sync is disabled when the Pure Audio listening mode is selected, or when the Direct listening mode is used with an analog input source.

76