Onkyo SR607 instruction manual Speaker Settings, Powered Zone

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the Audyssey 2EQ™ Room Correction and Speaker Setup again (see page 46).

If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms.

If you’ve connected your front speakers to the FRONT L/R and SURR BACK L/R terminal posts for bi-amping, you must change the “Speaker Type” setting. For hookup information, see “Bi-amping the Front Speakers” on page 19.

Notes:

•When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room.

•Before you change these settings, turn down the volume.

1Press the [RECEIVER] button, followed by the [SETUP] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2 Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [ENTER]. The “Speaker Setup” menu appears.

2. Speaker Setup

1.Speaker Settings

2.Speaker Configuration

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

3	Use the Up and Down [q]/[w] but-
	tons to select “1. Speaker Set-
	tings”, and then press [ENTER].
	The “Speaker Settings” menu appears.
	2–1. Speaker Settings
	Speaker Impedance	6ohms
	Speaker Type	Normal
	Powered Zone 2	Not Act
	Surr Back/Front High	Surr Back

4	Use the Up and Down [q]/[w] but-
	tons to select “Speaker Imped-
	ance”, and then use the Left and
	Right [e]/[r] buttons to select:
	4ohms: Select if the impedance of any
	speaker is 4 ohms or more but
	less than 6.
	6ohms: Select if the impedances of all
	speakers are between 6 and
	16 ohms.
	Note:
	North American/Taiwan models do not
	support speakers with an impedance of
	less than 6 ohms.
5	Use the Up and Down [q]/[w] but-
	tons to select “Speaker Type”,
	and then use the Left and Right
	[e]/[r] buttons to select:
	Normal: Select this if you’ve con-
	nected your front speakers
	normally.
	Bi-Amp:Select this if you’ve con-
	nected your front speakers for
	bi-amped operation.
	Note:
	Powered Zone 2 cannot be used if
	“Speaker Type” is set to “Bi-Amp”.
6	Use the Up and Down [q]/[w] but-
	tons to select “Surr Back/Front

High”, and then use the Left and

Right [e]/[r] buttons to select:

Front High:

FRONT HIGH L/R speakers can be used.

Surr Back:

SURR BACK L/R speakers can be used.

Note:

• If the “Speaker Type” setting is set to “Bi-Amp”, or Powered Zone 2 is set to “Not Act”, this setting cannot be selected.

7	Press the [SETUP] button.
	The setup menu closes.

Powered Zone 2

See “Zone 2” on page 85.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

43