Advanced Setup—Continued
■Lip Sync
The AV receiver can be set to automatically correct any delay between the video and the audio, based on the data from the connected monitor.
Disable: HDMI lip sync disabled (default).
Enable: HDMI lip sync enabled.
Notes:
•This function works only if your
•You can check the amount of delay being applied by the HDMI Lip Sync function on the A/V Sync screen (see page 78).
■x.v.Color
If your HDMI source and
Disable: “x.v.Color” disabled (default).
Enable: “x.v.Color” enabled.
Notes:
•If the color is unnatural when “x.v.Color” is set to “Enable”, change the setting to “Disable”.
•Refer to the connected component’s instruction man- ual for details.
■HDMI Control (RIHD)
This function allows 
Off: 
disabled (default).
On: 
enabled.
Notes:
•
, which stands for Remote Interactive over HDMI, is the name of the system control function found on Onkyo components. The AV receiver can be used with CEC (Consumer Electronics Control), which allows system control over HDMI and is part of the HDMI standard. CEC provides interoperability between various components, however, operation with
components other than 
When set to “On” and close the menu, the name of
connected 
“Search…” → “(name)” → “RIHD ON”
When the AV receiver cannot receive the name of the component, it is displayed as “Player*” or “Recorder*”, etc (“*” means the number of two or more component).
When set to “Off” and close the menu, “RIHD OFF” are displayed on the AV receiver.
“Disconnect” → “RIHD OFF”
•When an 
AV receiver, the name of the DVD player is displayed on the AV receiver.
•Set to “Off” when a connected piece of equipment is not compatible or it is unclear whether the equipment is compatible or not.
•If movement is unnatural when set to “On”, change the setting to “Off”.
•Refer to the connected component’s instruction man- ual for details.
Power Control
To link the power functions of 
This setting is set to “On” automatically when the above “HDMI Control (RIHD)” is set to “On”.
Off: Power Control disabled.
On: Power Control enabled.
Notes:
•The “Power Control” setting can be set only when the above “HDMI Control (RIHD)” setting is set to “On”.
•HDMI power control only works with 
•When set to “On”, power consumption will increase.
•When set to “On”, regardless of whether the AV receiver is On or on Standby, both audio and video received by an HDMI input will be output by the HDMI OUT for playback on the TV or other compo- nent that’s connected to the HDMI OUT.
•Refer to the connected component’s instruction man- ual for details.
TV Control
Set to “On” when you want to control the AV receiver
from an 
Off: TV Control disabled.
On: TV Control enabled.
Notes:
•Do not assign the component connected with the HDMI input to the TV/TAPE selector when you set “TV Control” setting to “On”. Otherwise, appropriate CEC (Consumer Electronics Control) operation is not guaranteed.
•Set to “Off” when the TV is not compatible or when it is unclear whether the TV is compatible or not.
•The “TV Control” setting can be set only when the above “HDMI Control (RIHD)” and “Power Control” settings are both set to “On”.
•Refer to the connected component’s instruction man- ual for details.
Note:
After changing the settings of the “HDMI Control (RIHD)”, “Power Control”, or “TV Control”, turn off the power to all connected pieces of equipment and then turn them on again. Refer to the User’s Manu- als for all connected pieces of equipment.
82