Onkyo SR607 instruction manual Entering Remote Control Codes

Controlling Other Components—Continued

Entering Remote Control Codes

You’ll need to enter a code for each component that you want to control.

Remote

1	Look up the appropriate remote
	control code in the separate
	Remote Control Codes list.
	The codes are organized by category
	(e.g., DVD player, TV, etc.).

Indicator DISPLAY

REMOTE

MODE

Number buttons

2

(3 seconds)

While holding down the REMOTE MODE button to which you want to enter a code, press and hold down the [DISPLAY] button (about 3 seconds).

Notes:

•Remote control codes cannot be entered for the [RECEIVER] and [ZONE 2] buttons.

•Only TV remote control codes can be entered for the [TV] button.

•Apart from the [RECEIVER], [TV], and [ZONE 2] buttons, remote con- trol codes from any category can be entered for the REMOTE MODE buttons. However, these buttons also work as input selector buttons (page 51), so choose a REMOTE MODE button that corresponds with the input to which you connect your component. For example, if you con- nect your CD player to the CD input, choose the [CD] button when enter- ing its remote control code.

3	Within 30 seconds, use the num-
	ber buttons to enter the 5-digit
	remote control code.

The Remote indicator flashes twice. If the remote control code is not entered successfully, the Remote indicator will flash once slowly.

Note:

The remote control codes provided are correct at the time of printing, but are subject to change.

91