JVC DT-V9L3D Example of the wave form monitor, Ex. When Marking is set to on and Level is set to

Operation guide

Shows the buttons for each operation.

•The menu automatically disappears in about 30 seconds after the previous operation.

•Some items may not appear on the menu depending on the input or the input signal.

•The items controlled by the MAKE system do not appear on the menu.

NOTE

Example of the wave form monitor

Ex.: When “MARKING” is set to “ON” and “LEVEL” is set to “080”

Red White

• The wave which goes over the value set on “LEVEL” is indicated in red.

	Video signal
Start	End

WAVE FORM SETTING

Settings for the wave form monitor

Item		To do	Setting value
POSITION		Select the position of the wave form monitor.	1 (lower right), 2 (lower left), 3 (upper left),
			4 (upper right)
GAIN		Adjust the gain level for the incoming wave form	–10 – +10
		data.
OVER LEVEL		Select the over level for the incoming luminance	☞ “NOTE”
		signals.
	MARKING	Activates/deactivates the function to change the	OFF, ON
		color of a wave form when the signal exceeds the
		limit specified on “LEVEL” (☞ below).
	LEVEL	Adjust the lower limit for the luminance signal	070 –109
AUTO OFF		Activates/deactivates the function to make the	ON, OFF
		wave form monitor indication go off automatically
		15 minutes after displaying it.

SYNC FUNCTION

Settings for the synchronization with signals

Item	To do	Setting value
NO SYNC ACTION	Select the screen status when no signal is	OFF,
	coming in.	P.SAVE (power save mode),
		GRAY B. (gray screen)
DELAY TIME	Select the period until the screen status	30sec., 5min., 15min.
	changes as selected in “NO SYNC ACTION”
	after signals stop coming in.

•When setting “NO SYNC ACTION” to “GRAY B.,” the screen color changes to gray and the power consumption of the back light is saved by half.

Selecting “P.SAVE” (power save mode) saves more power consumption by turning off the back light.

ENGLISH13