Setting of Character SET, Information | JVC DT-V20L3DY, DT-V24L3DY

Shows the buttons for each operation.

•The menu automatically disappears in about 30 seconds after the previous operation.

•Some items may not appear on the menu depending on the input or the input signal.

•The items controlled by the MAKE system do not appear on the menu.

NOTE

Setting of “CHARACTER SET.”

Assign a name for each video source.

1Change the input to one that you want to assign a video source name for.

2 Select “CHARACTER SET.”

3Press buttons to select the first character.

•Each time you press button, the character changes as follows. Press button to reverse the order.

Space

4Press button to move the arrow to the next space.

• The characters entered before moving the arrow are memorized.

5Repeat steps 3 and 4 (10 characters at maximum).

6Press MENU button to store the name.

REMOTE SETTING (☞ “External Control” on pages 16 to 18)

Settings for the external control

Item	To do	Setting value
SERIAL TYPE	Select the input terminal used for external control by	RS232C, RS485
	serial communication.
PARALLEL TYPE	Select the external control method for the MAKE/	MAKE, TRIGGER, SET
	TRIGGER terminal.
PIN1, PIN2, PIN3,	Assign the control functions to the pins of the MAKE/	☞ “Functions controlled by the MAKE/
PIN4, PIN5	TRIGGER terminal.	TRIGGER system” on page 17
	• Assign a function to each pin terminal by selecting
	“SET” in “PARALLEL TYPE.” (The functions are
	assigned for “PIN6” – “PIN8” and you cannot
	change the assignment of these functions.)

Item	To do	Setting value
POSITION	Select the position to show the information display (☞ “On the	UPPER, LOWER
	Information Display” on page 7).
SOURCE ID	Select if the name assigned in “CHARACTER SET.” is displayed on	OFF, ON
	the screen (☞ “On the Information Display” on page 7).
CHARACTER SET.*1	Assign a name to each video source as you like (10 characters at	☞ “NOTE”
	maximum). You can also enter a name using the RS-232C system.
STATUS DISPLAY	Select if the status of the current input and the setting of muting are	AUTO, OFF, ON
	displayed on the screen (☞ “On the Status Display” on page 7).
CRC ERROR	Select if the CRC error indication for the input HD SDI signal is displayed	ON, OFF
	on the screen (☞ “On the Information Display” on page 7).
SUB HOUR METER	Display the hours of use (unit: hour). You can reset this item.
MODEL	Display the model name of the monitor.
VERSION	Display the version of the monitor.
HOUR METER	Display the total hours of use (unit: hour). This item is used for maintenance of the monitor. You
	cannot reset this item.

*1 Memorized for each input.

Turns on (or off) the control lock function to disable the buttons on the front panel.

•The following operations are available even when this function is activated.

–Turning on/off (on standby) the monitor

–Displaying the SET-UP MENU (by pressing button while holding button) and turning “CONTROL LOCK” to “OFF”

–Operating the monitor by an external control

If you try other operations, “ Control lock on!” appears on the screen.

Restores all the settings and adjustments of the monitor to the default.

•“HOUR METER” and the settings done by using the adjustment knobs on the front panel will not be reset.

•After performing “all reset,” the monitor is turned off then turned on automatically.