Installation
CAUTION
•Do not rest your arm on the monitor or lean against the monitor.
•Do not touch the LCD panel when installing the monitor.
•Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.
You can place the monitor in the following two ways when using it on the supplied stand.
4
To detach the stand
CAUTION
Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.
Attachment screws |
You can tilt the monitor from about 6° upward to about 6° downward.
•When the monitor is not tilted (0°), the guidelines align as illustrated below.
Monitor
Stand
About 6°
0°
About 6°
When the stand plate is attached to the higher position of the stand body (☞ “To adjust the stand height” on page 5), you can place the monitor as illustrated below.
1Remove the screws on the left and right sides of the stand (see the illustration below), then lift the stand up by about 148°.
Screw (silver)
About 148°
2Attach the removed screws and place the monitor as illustrated below.
Screw holes for stand | Stand body | |
attachment | ||
|
Monitor
The illustration of the monitor is of
To install the stand
When attaching the stand to the monitor, insert the guides of the stand into the guide holes on the monitor to place the stand in the correct position. Then fix the stand firmly with the attachment screws.
Guidelines
The illustration of the monitor is of
•You can select the stand
CAUTION
•Be careful not to pinch your fingers in the gap between the monitor and the stand.
•When the stand plate is attached to the lower position of the stand body, you cannot tilt the monitor downward.
The illustrations of the monitor are of
•To place the monitor as illustrated on the left again, remove the screws on the left and right sides of the stand, return the monitor angle to 0°, then reattach the removed screws.
CAUTION
•When lifting up the stand...
–lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.
–be careful not to pinch your fingers in the moving parts.
•Make sure of lifting the stand up until it stops (about 148°); otherwise the monitor may fall over.
•Place the monitor on a mat to avoid scratching the table surface.
•Do not lift up the stand when the stand plate is attached to the lower position of the stand body.
Guides
Stand plate
Screw holes for stand attachment
Stand body
Guide holes
Monitor
The illustration of the monitor is of