Onkyo S3200 instruction manual Connecting an Outdoor FM Antenna, Connecting an Outdoor AM Antenna

Page 20

Connecting the AV receiver—Continued

Connecting an Outdoor FM Antenna

If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.

Connecting an Outdoor AM Antenna

If good reception cannot be achieved using the supplied AM loop antenna, an outdoor AM antenna can be used in addition to the loop antenna, as shown.

Outdoor antenna

Insulated antenna cable

AM loop antenna

Notes:

•Outdoor FM antennas work best outside, but usable results can sometimes be obtained when installed in an attic or loft.

•For best results, install the outdoor FM antenna well away from tall buildings, preferably with a clear line of sight to your local FM transmitter.

•Outdoor antenna should be located away from possible noise sources, such as neon signs, busy roads, etc.

•For safety reasons, outdoor antenna should be situated well away from power lines and other high-voltage equipment.

•Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock hazards.

■Using a TV/FM Antenna Splitter

It’s best not to use the same antenna for both FM and TV reception, as this can cause interference problems. If circumstances demand it, use a TV/FM antenna splitter, as shown.

Outdoor AM antennas work best when installed horizontally outside, but good results can sometimes be obtained indoors by mounting horizontally above a window. Note that the AM loop antenna should be left connected.

Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock hazards.

TV/FM antenna splitter

To AV receiver

To TV (or VCR)

20

Image 20

Contents HT-S3200 Important Safety Instructions AvisPrecautions PowerPreventing Hearing Loss Caution Batteries and Heat Exposure WarningSpeaker Precautions PlacementUsing Close to a TV or Computer Input Signal WarningContents Package Contents Package Contents HTP-370 Speaker Package FeaturesHT-R370 AV Receiver Front & Rear Panels Front PanelFront & Rear Panels DisplayRear Panel DVD/BD CBL/SATVCR/DVR IN/OUT Speaker Package RearSpeaker terminals Keyhole slotsRemote Controller Controlling the AV receiverAiming the Remote Controller Remote ControllerInstalling the Batteries Speaker Set B Sub Room Speaker Set a Main Room Enjoying Home TheaterSpeaker Sets a and B Connecting the AV receiver Connecting Your SpeakersSpeaker Connection Precautions Connecting the Speaker CablesConnecting the AV receiver Terminals are gripping the bare wires, notStrip 3/8 10 mm InsulationWall Mounting Using the Rubber Stoppers for a More Stable PlatformUsing the Floor Pads for Subwoofer Connecting Antenna Connecting the Indoor FM AntennaConnecting the AM Loop Antenna Attach the FM antenna, as shown North American ModelUsing a TV/FM Antenna Splitter Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna About AV Connections Optical Digital JacksAV Connection Color Coding AV Cables and JacksConnecting Audio and Video Signals to the AV receiver Which Connections Should I Use?Video Connection Formats Audio Connection FormatsConnecting Components with Hdmi About HdmiAbout Copyright Protection Pass-ThruMaking Hdmi Connections TipStep DVD/BD player StepConnecting a TV or Projector Video ConnectionAudio Connection HintConnecting a DVD/BD player DVD/BD playerConnecting a VCR or DVR for Playback VCR or DVRConnecting a VCR or DVR for Recording Composite video inputSatellite, cable, set-top box, etc Connecting a Portable Audio player Make the audio connection aPortable Audio Player Analog audio Line outputTurntable MM with no Phono Preamp Built-in Connecting a CD Player or TurntableCD Player or Turntable MM with Built-in Phono Preamp Step Connecting a Cassette, CDR, MiniDisc, or DAT Recorder Signal flow Cassette, CDR, MD, or DAT recorderIf Your iPod Doesn’t Support Video Connecting an RI DockIf Your iPod Supports Video Connecting Onkyo u Components Connecting the Power CordAuto Power On/Standby Direct ChangeUp and Running in a Few Easy Steps Turning On the AV receiverTurning On and Standby First Time Setup Component Video Input SetupDigital Input Setup Press the Setup buttonFirst Time Setup Changing the Input DisplaySelect a listening mode and enjoy Basic OperationsBasic AV receiver Operation Start playback on the source componentSetting the Display Brightness Using the Sleep TimerBasic Operations Muting the AV receiver7Using Headphones Adjusting the Bass & TrebleDisplaying Source Information BassUsing the Music Optimizer Specifying the Digital Signal FormatAuto default Press and hold Audio button for about 8 secondsUse the Left and Right e/r buttons to select AM/FM Frequency Step SetupListening to the Radio Listening to AM/FM Stations Tuning into AM/FM Radio StationsListening to the Radio Tuning into Stations by Frequency Displaying AM/FM Radio InformationD.TUN button Band FrequencySelecting Presets Presetting AM/FM StationsDeleting Presets Camcorder Video signal audio signal CD player RecordingRecording the Input Source Recording from Different AV SourcesUsing the Listening Modes Selecting with the Remote ControllerSelecting the Listening Modes Selecting on the AV receiverMono/Multiplex Sources Using the Listening ModesListening Modes Available for Each Source Format Stereo Source Multichannel Sources DTSAbout the Listening Modes Onkyo Original DSP ModesAdvanced Setup Common Procedures in Setup MenuSpeaker Settings Sp Config Speaker ConfigurationAdvanced Setup Crossover Crossover FrequencyDouble Bass Sp Distance Speaker DistanceEqualizer Equalizer Settings Off Tone off, No equalizing apply defaultLevel Cal Speaker Levels Calibration Left, Center, Right, SurrRight, SurrLeft, SubwooferPLII/Neo6 Settings Audio Adjust SettingsAudio Adjust Multiplex/Mono Settings Audyssey Settings Hardware Setup Theater-Dimensional SettingHardware Remote ID TunerUsing the Audio Settings Tone Control SettingsLate Night Function CinemaFILTERAudyssey Dynamic Volume Music OptimizerSpeaker Levels SyncPreprogrammed Remote Control Codes Entering Remote Control CodesSee page 61 for the Onkyo component’s remote control code Controlling Other ComponentsResetting the Remote Controller Remote Control Codes for Onkyo Components Connected via uResetting the Remote Mode Buttons Controlling Other ComponentsControlling a DVD Player, or DVD Recorder Controlling a CD Player, CD Recorder, or MD Player Controlling an RI Dock Controlling a Cassette Recorder Previous and Next 7/6 buttonsRewind and Fast Forward 5/4 buttons Reverse Play t buttonTroubleshooting Troubleshooting Sound changes when I connect my headphones Can’t control other componentsCan’t record How do I change the language of a multiplex sourceSpecifications Amplifier SectionVideo Section Tuner SectionSpecifications 1ch Home Theater Speaker PackageMemo Onkyo Europe Electronics GmbH Onkyo Europe UK OfficeSpeaker Set a Hookup RemoteAV Component Hookup ONKYOe Onkyo USA Corporation Limited Warranty USA Onkyo USA Corporation Limited Warranty Canada Garantie limitee de Onkyo USA Corporation Canada