Onkyo S3200 Basic Operations, Setting the Display Brightness, Muting the AV receiver

Basic Operations—Continued

This section explains functions that can be used with any input source.

	DISPLAY
Press
[RECEIVER]	MUTING
first

TONE, +, –

DIMMER SLEEP

MUSIC OPTIMIZER –, +, TONE DISPLAY

PHONES DIMMER

Setting the Display Brightness

You can adjust the brightness of the display.

Remote	Press the [RECEIVER] button,
controller	and then press the remote
	controller’s [DIMMER] button
	repeatedly to select: dim,
	dimmer, or normal brightness.
	You can also use the AV receiver’s
	[DIMMER] button.
AV receiver

Muting the AV receiver

You can temporarily mute the output of the AV receiver.

Press the [RECEIVER] button, and then press the remote controller’s [MUTING] button.

The output is muted and the MUTING indicator flashes on the display.

To unmute the AV receiver, press the remote controller’s [MUTING] button again, or adjust the volume. The output is unmuted and the MUTING indicator goes off.

Muting is cancelled when the AV receiver is set to Standby.

Using the Sleep Timer

With the sleep timer, you can set the AV receiver so that it turns off automatically after a specified period.

Press the [RECEIVER] button, and then press the remote controller’s [SLEEP] button repeatedly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about 5 seconds, then the previous display reappears.

SLEEP indicator

To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears.

To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

39