Onkyo DR-C500 instruction manual Speaker Setup, Selecting the number of speaker channels

Speaker Setup

You need to set up the speaker configuration for the speaker system connected to the FRONT SPEAKERS A connectors.

Notes

•Speaker setup cannot be done if;

–Headphones are connected, or

–The FRONT SPEAKERS B system is On (see page 31).

•It is not necessary to set the parameters again once you have completed the setup unless you change the speaker configuration.

Before operating the remote controller

Press MODE RCVR/VCR.

RCVR /VCR

The remote controller remains in the RCVR/VCR mode, until another MODE button is pressed.

	DBY		/O
	N
S	TA		N	SEND / LEARN
								LIGHT
					MODE
		DVD		RCVR /VCR			T V	CBL / SAT
			INPUT
						DIMMER		SLEEP
		1		2			3
								PRESET
		4		5			6
								MASTER
								VOLUME
		7		8			9
		-- / ---				ENTER
		MEM		0			CLR
				A-B		RANDOM
		AT						M
		E						UTI
	EP							NG
	R
			CH		VOLUME			CH
						UP
			–					+
		TOP MENU					MENU
					ENTER
							TV / VCR
		RETURN				DOWN	ON SCREEN
							PLAY
SP A		SP A		SP B		FM MODE		SURROUND
		SLOW		STEP		PRGV		DISC
		SP SETUP		IPM	ACOUSTIC		LATE
					CONTROL		NIGHT
SP SETUP		AUDIO		ANGLE SUBTITLE			ZOOM
SW MODE		SW MODE T.TONE			CH SEL DISTANCE

RC-504M

Selecting the number of speaker channels

1	Press SP A to select “SP A.”
Remote
controller only
SP A
SLOW
	Note
	The unit must be set to “SP A” for the following
	operations.
2	Press SP SETUP repeatedly to

The normal display resumes in three seconds.

Speaker configuration indicator in the lower right corner shows the current speaker configuration.

Note

•To check the present setting while the normal display is displayed, press SP SETUP once. To change the setting, press the button repeatedly within three seconds.

Selecting the Subwoofer mode

SP SETUP	select the number of channels for
	the Speaker A system.
	Speaker configuration indicators indicate
	current speaker configuration.

Speaker Position

Input format

Output format

Speaker Position: Indicates the position of a selected channel.

Input format: Lights when a signal is input for that channel.

Output format: Lights when a signal is output for that channel.

Pressing the button repeatedly within three seconds changes the number of channels as follows (the corresponding speaker configuration is described in parentheses):

→Speaker 5ch

(Front left, center, and right,

plus surround left and right speakers)

↓

Speaker 2ch

(Front left and right speakers)

Remote controller

SW MODE

Press SW MODE on the remote controller.

SW indicator lights up when SW Mode 1, SW Mode 2 or SW Mode 3 is selected.

With the first press of the button, you can check the present setting. Then each press of the button changes the subwoofer mode as follows (a tip on how to select the right subwoofer mode is in parentheses):

SW MODE 1

→(When small–with limited bass signal handling–front speakers are

connected)

↓

SW MODE 2

(When large–wideband–front speakers

are connected)

↓

SW MODE 3

(When large–wideband speakers are

connected to all channel)

↓

SW Off

(When no subwoofer is connected)

↓

Speaker 3ch

(Front left, center, and right speakers)

↓

Speaker 4ch

(Front left and right, plus surround left and right speakers)

24

The initial setting is SW MODE 1.