Onkyo DR-C500 instruction manual Erasing the programmed command from one button

Controlling other components connected to the DVD Changer Receiver

	NDBY	/O					SEND/LEARN
S	TA	N	SEND / LEARN				indicator
						LIGHT
			MODE				MODE buttons
	DVD	RCVR /VCR		T V		CBL / SAT
		INPUT
				DIMMER		SLEEP
	1		2	3
						PRESET
	4		5	6
						MASTER
						VOLUME
	7		8	9
	-- / ---			ENTER
	MEM		0	CLR
		A-B		RANDOM
	AT					M
	E					UTI
	EP					NG
	R
		CH	VOLUME			CH
				UP
		–				+
	TOP MENU					MENU
			ENTER
						TV / VCR	ENTER
	RETURN			DOWN	ON SCREEN

PLAY

SP A	SP B		FM MODE		SURROUND
SLOW	STEP		PRGV		DISC
SP SETUP	IPM	ACOUSTIC		LATE
		CONTROL		NIGHT
AUDIO	ANGLE SUBTITLE			ZOOM
SW MODE T.TONE		CH SEL DISTANCE

RC-504M

Erasing the programmed command from one button

You can only erase memorized commands and not preset ones.

1				Press and hold down the desired
	MODE			MODE button for the command,
DVD	RCVR/VCR	T V	CBL / SAT	press the ENTER button, and then
				release both buttons.
				When you press the MODE button, the
				SEND/LEARN indicator lights. When you
	ENTER			press the ENTER button, the lamp turns
				off. When you release the buttons, the
				lamp lights again.
2				Press and release the button for the
				command you wish to erase.
				When you press the button, the SEND/
				LEARN indicator turns off. When you
				release the button, the lamp lights
				again.
3				Press and release the same button
				again.

The SEND/LEARN indicator flashes twice slowly. The memorized command is erased.

Note

•If no button is pressed for more than 30 seconds during the erasing procedure, the remote controller exits the erasing mode. Resume from Step 1.

Erasing all the commands programmed under a MODE button

1			Press and hold down the desired
	MODE		MODE button, press the ENTER
DVD	RCVR/VCR T V	CBL / SAT	button twice, and then release both
			buttons.
			When you press the MODE button, the
			SEND/LEARN indicator lights. When you
			press the ENTER button, the lamp turns off.
	ENTER		When you release the buttons, the lamp
			lights again.
2			Press and release the same MODE
			button again.

When you release the button, the SEND/ LEARN indicator flashes twice slowly. This erases all the commands memorized to the MODE button.

Notes

•If no button is pressed for more than 30 seconds during the erasing procedure, the remote controller exits the erasing mode. Resume from Step 1.

•If you perform an invalid operation during erasing, the SEND/ LEARN indicator flashes three times quickly, and the remote controller exits the erasing mode. Resume from Step 1.

•If many commands have been programmed to the MODE button, then the SEND/LEARN indicator may remain lit for up to 20 seconds during Step 2. This is not a malfunction.

62