Onkyo DR-C500 Listening to the Radio, Tuning Manually, Presetting Radio Stations

Listening to the Radio

	DBY	/O
	N
S	TA	N	SEND / LEARN
					LIGHT
			MODE
	DVD		RCVR/VCR	T V	CBL / SAT
		INPUT
				DIMMER	SLEEP
	1		2	3
					PRESET
	4		5	6
					MASTER
					VOLUME
	7		8	9
	-- / ---			ENTER
	MEM		0	CLR

There are two ways to select radio stations:

•Tuning manually

•Presetting radio stations then selecting the preset stations

Note

•10 AM and FM stations have already been preset. You can change these according to your preference.

Before operating the remote controller

Press MODE RCVR/VCR.

RCVR /VCR

	A-B		RANDOM
AT					M
E					UTI
EP					NG
R
CH		VOLUME			CH
			UP
–					+
TOP MENU				MENU
		ENTER
				TV / VCR
RETURN			DOWN	ON SCREEN
				PLAY
SP A	SP B		FM MODE		SURROUND
SLOW	STEP		PRGV		DISC
SP SETUP	IPM	ACOUSTIC		LATE
		CONTROL		NIGHT
AUDIO	ANGLE SUBTITLE			ZOOM
SW MODE T.TONE		CH SEL DISTANCE

RC-504M

Tuning Manually

1	Unit	Press INPUT	2 3
			/ repeatedly to
		select the band (FM or AM).

e.g. When FM is selected.

	Note
	• You can also select the band with the
	remote controller. See next page.
2 Unit only	Press and hold TUNING/PRESET
	4/¢ for about 0.5 seconds.

Auto tuning starts. The tuner frequency changes 0.1 MHz for FM and 10 kHz for AM.

When a broadcast is received, scanning stops and the frequency flashes in the display.

Appears when a broadcast is received.

•Manual tuning

The frequency changes until the TUNING/PRESET 4/¢ is pressed repeatedly.

3	While the frequency is flashing (for
	about 5 seconds), press TUNING/

PRESET 4/¢ to change the frequency.

•The frequency changes each time you press TUNING/PRESET 4/¢.

•You can change the frequency as long as the frequency in the display is flashing. Each press of either button causes the frequency to flash for about 5 seconds.

Tuning in a weak frequency (only for FM stations)

When you tune in a stereo FM station, the ST indicator lights up if the signal is sufficiently strong.

If the signal is weak, you may not be able to tune to the station. In this case, press FM MODE. The ST indicator and AUTO indicator goes off. Then select the station to which you want to listen.

(At this time, the station will be monaural and interstation noise will be heard.)

Remote Controller

Only

FM MODE

PRGV

Presetting Radio Stations

You can preset up to 30 stations.

1		Tune in the radio station you wish
		to preset (see steps in the left
		column of this page).
2	Unit only	Press PRESET MEMORY.
		The MEM. indicator lights and the preset

number starts flashing in the display.

3	While the MEM. indicator is lit (for
	about 8 seconds), press TUNING/

PRESET 4/¢ to select the preset number.

4	Press PRESET MEMORY.
	The radio station is registered to the

preset channel.

To register another preset station, repeat steps 1 to 4.

52