JVC GV-PT1 manual Troubleshooting

TROUBLESHOOTING			33
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
	The power doesn’t	⬤ The video printer’s power cord is not	⬤ Plug the power cord into an AC
	come on.	plugged into an AC outlet.	outlet.
	The error lamp lights	⬤ An error message appears on the	⬤ Refer to the list of error messages
	or begins blinking.	connected TV’s screen.	(☞ pg. 32).
		⬤ A malfunction has occurred but no	⬤ Turn off the video printer’s power,
		message appears.	unplug the power cord and plug it
			in again, then turn the power back
			on. If the trouble does not clear,
			contact your JVC dealer.
	The video from the	⬤ The video cable is not properly	⬤ Connect the video cable correctly
	connected image	connected.	(☞ pg. 12).
	source does not	⬤ The connected TV has not been set to its	⬤ Set the TV to its Video mode.
	appear on the	Video input mode.
	connected TV.	⬤ The image source input signal has been	⬤ Disconnect all higher priority
		superceded by a priority input.	inputs (☞ pg. 9, 13 and also refer
			to the TV’s instruction manual).
	The image on the	⬤ You’re looking at a stored image, not the	⬤ Press PICTURE SELECT to view
	connected TV is	input image.	the input image.
	frozen.
	The stored image has	⬤ After storing the image, the video	⬤ Turning off the power erases all
	disappeared.	printer’s power was turned off.	stored images. To retain images,
			do not turn the power off.
	The inserted print	⬤ This video printer employs the 3-color
	sheet comes out	consecutive printing method (Yellow,
	several times during	Magenta, Cyan). As each color is printed,
	printing.	the print sheet protrudes partially from
		the video printer. This is normal. Do not
		attempt to remove the print sheet until
		the Print Lamp stops blinking but stays lit,
		signaling the end of printing.
	During Multi-Print,	⬤ When using the Multi-Print mode set to
	the size of the shaded	either 4 or 16, the segment where a
	segment changes.	scene is to be stored may change in size
		depending on the TV or the image source
		used. This is not a malfunction. The
		actual size of the printed image, or the
		position in which it is to be stored, do not
		change.
	The color of a printed	⬤ The ink sheet cartridge being used does	⬤ Make sure you use the ink sheet
	image is thin or	not match the print medium.	cartridge appropriate for the type
	incorrect.	⬤ The color seen on the connected TV and	of print sheets in use (☞ pg. 11).
		the actual color of the image may differ
		slightly. This is not a malfunction.
	The Strobe print	⬤ “CONTENT” in the Print Menu is set for	⬤ Set “CONTENT” for “STROBE
	mode doesn’t work.	“SELECTED PIX”.	PIX” (☞ pg. 24).
	An unusual image	⬤ The Title Impose mode is activated.	⬤ Access the Mode Select Menu and
	appears on the		deactivate the Title Impose mode
	connected TV.		(☞ pg. 27).
	Detailed portions of	⬤ “PIX STABILIZER” was set to “ON”	⬤ Set “PIX STABILIZER” to “OFF”
	the print don’t come	during printing.	and try printing the image again.
	out clearly.