JVC DLA-M4000LU manual Setting Up Channels SWNo. setup, Press the page Back button to set

• When you press PAGE BACK, the switcher number is set, and the display returns to the “CHANNEL setup/selection menu”.

• Be careful that if you set the same switcher number to a few channels and operate using the switcher number, the youngest- number channel is switched to because channels are read in the order of channel numbers.

Operating the Main Menu (Cont.)

Setting Up Channels (SWNo. setup)

■Remote control unit

QUICK
ALIGN.	OPERATE
	AV HIDE
PRESET	PAGE BACK	PAGE BACK button
LENS LOCK
	N
	M
	E
	N
	U
	/
UNLOCK	E
	T
	E
	R
		MENU/ENTER button

■When a switcher number “SWNo” is selected :

The “Switcher number setup menu” is displayed.

• To be able to display a menu, a “SOURCE” needs to be already set.

S W I T C H E R

S W I T C H E R NO. 1

AV RGB/COMPUTER

U T +

SHIFT ZOOM FOCUS

D W –

LENS

(SWITCHER No. setting menu)

1 Press MENU/ENTER toward the 2 or

3mark to select a switcher number.

•Numbers that you can select from are numbers from 1 to 20 and characters “77” that signify non-registration.

•If you press MENU/ENTER toward the 2 mark, the number becomes smaller, and pressing the button toward the 3 mark makes the number larger.

•If you select “ 77”, “SWNo” will be deselected.

• If the selected channel is the same with the one in ( ) under the “CHANNEL” display at the top of the CHANNEL setup selection menu, the registration or settings cannot be cleared.

■CHANNEL setup •selection menu

2 Press the PAGE BACK button to set.

C H A N N E L

		( A U T O )
CH	L I N E	S O U R C E	SWNo
1	Y / C	N T S C ( 4 8 0 i )	1
2	V I D E O P A L / S E C A M		2
3	77777	777777777	77
4	77777	777777777	77
5	77777	777777777	77
6	77777	777777777	77
7	77777	777777777	77
8	77777	777777777	77
9	77777	777777777	77
10	77777	777777777	77

Note

•The selected item is shown in magenta color. Items shown in gray color cannot be operated or set in the current mode. (If no line is registered, you cannot set any “SW No” item.)

Note

•You can automatically switch the channels of the projector by specifying a switcher number through an external controller.

As an example, if switcher number 1 (SWNo1) has been registered to channel number 1 (CH1), specifying switcher number 1 (SWNo1) automatically switches the projector to channel number 1 (CH1). (For this operation, a setup is required to communicate between the projector and the external controller.)

For information on external controllers, contact the dealer where you purchased your projector.

51