Onkyo HT-RC260 instruction manual Changing the Input Display, Using Headphones

Room Correction and Speaker Setup

Note

*1 If Direct listening mode is selected, “Dynamic EQ” and “Dynamic Volume” cannot be selected.

*2 Only when you have selected “Custom” in the “Picture Mode” (➔ 42), pressing ENTER allows you to adjust the fol- lowing items; “Brightness”, “Contrast”, “Hue”, and “Satu- ration”. Press RETURN to return to the original Video menu.

*3 Depending on the input source and listening mode, not all channels shown here output the sound.

*4 When you have entered a custom name in “Name Edit” (➔ 40), the input source is displayed with that name. But even if not, the component name may be displayed if the AV receiver receives it via HDMI connection (➔ 15).

*5 For the PORT input selector, the name of Universal Port Option Dock will be displayed.

Changing the Input Display

When you connect an u-capable Onkyo component, you must configure the input display so that ucan work properly.

This setting can be done only from the front panel.

1 Press TV/CD, GAME or VCR/DVR so that “TV/ CD”, “GAME” or “VCR/DVR” appears on the display.

2 Press and hold down TV/CD, GAME or VCR/DVR (about 3 seconds) to change the input display. Repeat this step to select “MD”, “CDR”, “DOCK” or “TAPE”.

For the TV/CD input selector, the input display changes in this order:

TV/CD → MD → CDR

→	TAPE	→	DOCK
				→

For the GAME input selector, the setting changes in this order:

GAME ↔ DOCK

For the VCR/DVR input selector, the setting changes in this order:

VCR/DVR ↔ DOCK

Note

•DOCK can be selected for the TV/CD, GAME or VCR/DVR input selector, but not at the same time.

•Enter the appropriate remote control code before using the remote controller for the first time (➔ 55).

En

Using Headphones

Connect a pair of stereo headphones with a stan- dard plug (1/4 inch or 6.3 mm) to the PHONES jack.

Note

•Always turn down the volume before connecting your head- phones.

•While the headphones plug is inserted in the PHONES jack, the speakers are turned off. (The Powered Zone 2 speakers are not turned off.)

•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono or Direct.

•Only the Stereo, Direct and Mono listening modes can be used with headphones.

Audyssey 2EQ® Room Correction and Speaker Setup

With the supplied calibrated microphone, Audyssey 2EQ automatically determines the number of speakers con- nected, their size for purposes of bass management, opti- mum crossover frequencies to the subwoofer (if present), and distances from the primary listening position. Audyssey 2EQ then removes the distortion caused by room acoustics by capturing room acoustical problems over the listening area in both the frequency and time domain. The result is clear, well-balanced sound for every- one. Enabling Audyssey 2EQ allows you to also use Audyssey Dynamic EQ™, which maintains the proper octave-to-octave balance at any volume level (➔ 39). Before using this function, connect and position all of your speakers.

If “Dynamic EQ” is set to “On” (➔ 39), the “Equalizer” setting will be set to “Audyssey” (➔ 37). On the other hand, if it is set to “Off”, the “Dynamic Volume” setting will be set to “Off” (➔ 39).

It takes about 15 minutes to complete Audyssey 2EQ for three positions. Total

measurement time varies depending on the number of speakers.

22