Onkyo HT-RC260 Adjusting the Bass & Treble, Setting the Incoming Digital Signal Fixed Mode

`COAX:

This can be selected when COAXIAL IN has been assigned as an input source. If both coaxial and opti- cal inputs have been assigned, coaxial input is auto- matically selected as a priority.

`OPT:

This can be selected when OPTICAL IN has been assigned as an input source. If both coaxial and opti- cal inputs have been assigned, optical input is auto- matically selected as a priority.

`Analog:

The AV receiver always outputs analog signals.

Note

•The setting is stored individually for each input selector.

•This setting can be made only for the input source that is assigned as HDMI IN, COAXIAL IN, or OPTICAL IN.

*1 You can select “ARC” if you select the TV/CD input selector. But you cannot select it if you’ve selected “Off” in the “Audio Return Channel” setting (➔ 45).

Adjusting the Bass & Treble

You can adjust the bass and treble for the front speakers, except when the Direct listening mode is selected.

1	Press TONE on the AV receiver repeatedly to
	select either “Bass” or “Treble”.
2	Use TONE LEVEL +/– on the AV receiver to
	adjust.

■Bass

■Treble

See “Bass” and “Treble” in “Tone Control Settings” (➔ 45).

Note

•To bypass the bass and treble tone circuits, select the Direct lis- tening mode.

•Alternatively, you can use the remote controller’s AUDIO and arrow buttons (➔ 21).

Setting the Incoming Digital Signal (Fixed

Mode)

By pressing ENTER while selecting “HDMI”, “COAX”, “OPT” in the “Audio Selector”, you can specify the input signal in the Fixed Mode. Pressing ENTER again allows you to return to the “Audio Selector” setting.

Normally, the AV receiver detects the signal format auto- matically. However, if you experience either of the follow- ing issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS.

•If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM.

•If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS.

`Auto:

The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead.

`PCM:

Only 2-channel PCM format input signals will be heard. If the input signal is not PCM, the PCM indi- cator will flash and noise may also be produced.

`DTS:

Only DTS (but not DTS-HD) format input signals will be heard. If the input signal is not DTS, the DTS indicator will flash and there will be no sound.

Note

•The setting is stored individually for each input selector.

•The setting will be reset to “Auto” when you change the setting in the “Audio Selector” (➔ 46).

En

47