Onkyo HT-RC260 instruction manual Precautions

Page 3

Precautions

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal without the permission of the copyright holder.

2.AC Fuse—The AC fuse inside the unit is not user-ser- viceable. If you cannot turn on the unit, contact your Onkyo dealer.

3.Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the unit immediately afterwards with a clean cloth. Don’t use abrasive cloths, thinners, alco- hol, or other chemical solvents, because they may damage the finish or remove the panel lettering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the volt- age requirements printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable (easily accessible) at all times.

Pressing ON/STANDBY to select Standby mode does not fully shutdown the unit. If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.

5.Preventing Hearing Loss Caution

Excessive sound pressure from earphones and head- phones can cause hearing loss.

6.Batteries and Heat Exposure Warning

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat as sunshine, fire or the like.

7.Never Touch this Unit with Wet Hands—Never han- dle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer.

8.Handling Notes

•If you need to transport this unit, use the original packaging to pack it how it was when you originally bought it.

•Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the case.

•This unit’s top and rear panels may get warm after prolonged use. This is normal.

•If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure to use it occasionally.

For U.S. models

FCC Information for User

CAUTION:

The user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turn- ing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit differ- ent from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV techni- cian for help.

For Canadian Models

NOTE: THIS CLASS B DIGITAL APPARATUS COM- PLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle pour les Canadien

REMARQUE: CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB- 003 DU CANADA.

Sur les modèles dont la fiche est polarisée:

ATTENTION: POUR ÉVITER LES CHOCS ÉLEC- TRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPON- DANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

En

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents HT-RC260 Away from the rear panel or wall, creating a flue-like Always consider the environmental issues and follow10 cm 4 at the rear. The rear edge of the shelf or Board above the apparatus shall be set 10 cmPrecautions Aiming the Remote Controller Supplied AccessoriesUsing the Remote Controller Installing the BatteriesContents Miscellaneous FeaturesAmplifier ProcessingFront Panel Hdmi Thru indicatorTUNING, Preset 25 to 26, arrow Front & Rear PanelsCENTER, FRONT, SURR, Surr Back or Front High or Front Wide UREMOTE Control jackDisplay Rear PanelControlling the tuner Remote ControllerControlling the AV Receiver Return buttonEnjoying Home Theater About Home TheaterSpeaker Connection Precautions Connecting the AV ReceiverConnecting Your Speakers Speaker ConfigurationConnecting the Speaker Cables Speaker cables, and twist the bare wires tightly, as shownScrew-type speaker terminals Strip 1/2 to 5/8 12 to 15 mm Bi-amping the Front Speakers Connecting a Powered SubwooferHdmi cable About AV ConnectionsConnected image with AV components AV Cables and JacksConnecting Components with Hdmi Jack Signal Components AssignableAudio return channel ARC function Rear Connecting External ComponentsHow to record the video FrontRemote Control Connecting Onkyo uComponentsConnecting Antenna System On/Auto Power OnAudio Connection Formats Signal SelectionWhich Connections Should I Use? Video Connection FormatsTurning On/Off the AV Receiver Turning OnTurning Off Playing the Connected Component Selecting the Language Used for the Onscreen Setup MenusSetting the Display Brightness Basic OperationsSelecting Speaker Layout Using the Sleep TimerUsing the Audio and Video Menus Muting the AV ReceiverMeasurement time varies depending on the number of speakers Using HeadphonesAudyssey 2EQ Room Correction and Speaker Setup Changing the Input DisplayEnter Using Audyssey 2EQError Messages Changing the Speaker Settings ManuallyUsing a Powered Subwoofer Listening to the Radio Using the TunerTuning into Radio Stations Listening to the RadioMode Presetting FM/AM StationsSelecting Presets Deleting PresetsOn your recorder, start recording RecordingAV Recording That you want to recordMOVIE/TV button Game button Using the Listening ModesListening Mode Buttons Selecting Listening ModesSpeaker Layout About Listening ModesExplanatory Notes Input SourceListening Modes DTS-HD High Resolution AudioDolby Digital Plus *5 Dolby TrueHDUnplugged Onkyo-Original DSP Listening ModesMenu Advanced SetupOn-screen Setup Menus Common Procedures in Setup MenuBD/DVD, VCR/DVR, CBL/SAT, GAME, TV/CD Port Input/Output AssignMonitor Out Hdmi InputDigital Audio Input Speaker SetupSpeaker Settings Component Video InputCenter*1, Surround*1, Surr Back*2*3*4*5 Speaker Terminal Assign Front High/Front Wide/Zone2SurrBack/Front High/Front Wide FrontLevel Calibration Audio AdjustEqualizer Settings Speaker DistanceAudyssey DSX DolbySource Setup Theater-DimensionalAudyssey IntelliVolume SyncName Edit Wide Mode*1*2 Picture AdjustGame Mode To correct a characterNoise Reduction*2 Picture Mode*1*2Film Mode*2 Edge Enhancement*2Miscellaneous Listening Mode PresetVolume Setup OSD SetupHardware Setup Remote IDTuner Lock Setup Using the Audio SettingsTone Control Settings Music Optimizer Audyssey SettingsSpeaker Levels Late NightAdjusting the Bass & Treble Setting the Incoming Digital Signal Fixed ModeBass Treble Zone Connecting ZoneConnecting Your Zone 2 Speakers Directly to the AV receiver Connecting Your Zone 2 Speakers to an Amp in ZoneControlling Zone 2 from the AV receiver Setting the Powered Zone Using ZoneMuting Zone Controlling Zone 2 with the Remote ControllerAdjusting the Volume for Zone Operating with the remote controllerOnkyo Dock Cable Connecting an Onkyo DockControlling iPod Models sold are different depending on the regionUP-A1 Dock Using the Onkyo DockWith the RI Control Controlling Your iPodRI Dock Without the RI ControlAvailable buttons Preprogrammed Remote Control Codes Looking up for Remote Control CodeControlling Other Components TV/CD Entering Remote Control CodesRemote Control Codes for Onkyo Components Connected via u Remote Mode BD/DVDControlling Other Components Resetting Remote Mode ButtonsResetting the Remote Controller You can reset the remote controller to its default settingsON/STANDBY Input TV VOL q / w Guide SetupComponents Buttons Cassettetape deckThere’s no sound, or it’s very quiet TroubleshootingStandby indicator flashes red Can’t turn on the AV receiverOnly the center speaker produces sound There’s no sound with a certain signal formatAbout DTS signals Only the front speakers produce soundOn screen display does not appear Remote controller doesn’t workThere’s no picture from a source connected to an Hdmi On-screen menus don’t appearZone 2 speakers produce no sound AV receiver’s remote controller doesn’t control your iPodSound changes when I connect my headphones Can’t recordNent Video OUT Important Note Regarding Video PlaybackTuner Section SpecificationsAmplifier Section General Video SectionAbout Hdmi Supported Audio FormatsAbout Copyright Protection Using an RIHD-compatible TV, Player, or Recorder About p-compatible componentsOperations that can be performed with p connection Confirm the settings How to connect and setupConfirm the connecting and setting Change each item in the Hdmi Setup as below1080p 1080i 720p 480p 480i Video Resolution ChartOutput Input OutputMemo Memo Memo Onkyo Europe Electronics GmbH UK Branch Onkyo Europe Electronics GmbH

HT-RC260 specifications

The Onkyo HT-RC260 is a versatile and powerful home theater receiver designed to enhance your audio-visual experience. While it may not be the latest model on the market, its combination of features and technologies makes it an excellent choice for those looking to create a rich and immersive entertainment environment.

One of the standout features of the HT-RC260 is its robust amplification system. This receiver provides 7.2 channels of surround sound, delivering up to 100 watts per channel. This level of power ensures that your home theater can fill a room with dynamic sound, making every movie, music track, or game come to life. The receiver also supports various surround sound formats, including Dolby TrueHD and DTS-HD Master Audio, allowing for a cinematic experience at home.

Connectivity options abound with the HT-RC260. It includes multiple HDMI inputs, accommodating various devices such as Blu-ray players, game consoles, and streaming devices. The HDMI ports support 3D video and 4K passthrough, ensuring compatibility with the latest video technologies. Additionally, the receiver features analog and digital audio inputs, allowing you to connect legacy devices with ease.

The Onkyo HT-RC260 also integrates advanced calibration technology known as AccuEQ. This feature automatically measures the characteristics of your room and adjusts the audio output for optimal sound quality. As a result, users can enjoy consistent audio experiences regardless of room size or shape.

For those who value convenience, the HT-RC260 supports network streaming services. Users can access popular platforms like Spotify, Pandora, and TuneIn via built-in Wi-Fi. Additionally, the receiver can connect to home networks via Ethernet, expanding your listening options and making it easy to enjoy your favorite music.

The user interface is straightforward, with an intuitive on-screen display that simplifies setup and operation. The included remote control allows easy access to all functions, making it user-friendly even for those who may not be tech-savvy.

In summary, the Onkyo HT-RC260 is an excellent choice for home theater enthusiasts. With its powerful amplification, diverse connectivity, advanced audio calibration, and network streaming capabilities, it offers a well-rounded solution for anyone seeking to elevate their audiovisual experience. Whether you are watching films, playing video games, or listening to music, the HT-RC260 provides an engaging and harmonious soundstage that will enhance your enjoyment for years to come.
Top Page Image Contents