Sharp Projector Remote Control setup guide On Switcher

Page 17

The following additional steps are necessary only if AUDIO OUTPUT is required. Please note that the speaker wire kept in the cart's black basket needs to connected to either the CPU1 or CPU2 wall plate from the workstation's speaker port )) (green-colored port on PC).

Please Note: The volume knob on the PRIMARY CONTROL is for the ceiling speakers. The volume knob on the RECEIVER is for the speakers on either side of the whiteboard.

5.0On SWITCHER

5.1Under the I/O label: Deselect the RGBS button (light should go off).

5.2Under the I/O label: Select the Audio button (light should come on).

5.3Select the CPU1 or CPU2 button, depending on which wall jack the computer cable is connected to (CPU1 or CPU2) (red light should come on).

5.4Select button above label for PROJ1 CPU Audio output (lower left- hand corner of switcher).

5.5Press ENTER [right side of switcher].

6.0Clean up

6.1Power OFF to Projectors.

6.2Power OFF to PRIMARY CONTROL.

6.3Power Off to Workstation.

6.4Disconnect all cables, but DO NOT disconnect the extension cables from either the cpu or the monitor cable.

17

Image 17
Contents Audio/visual equipment setup guide Table of Contents On Primary Control Console #1 Clean upOn Receiver Console #1 On Tape Deck Console #1Initial setup Setting Up and Displaying Laptop Computers RoomOn Switcher Console #1 see Image below and Figure Bl PR0J2 CPU button is for the projector nearest the windows Power OFF to Primary Control On SwitcherUsing the Mitsubishi Portable Projector Cheat Sheet Page Room 111- Cheat Sheet On Switcher Room 111- Step-by-Step Wall Jacks on south wall Macintosh Switcher Page On Switcher Projector Remote Control Should be one in classroom Only one projector can be chosen to display video images On VCR, U-Matic or Laserdisc Console #2 Using the P.A. System in Room 1 1 1 Cheat Sheet Using The Sharp Portable Projector- Cheat Sheet Page Using Video Output in Room 111 Cheat Sheet On VCR, U-Matic or Laserdisc Console #2 On Switcher Console #1 /see Image below and Figure Al Using Video Output in Room 111 Step-by-StepFigure a On Switcher On VCR. U-Matic or Laserdisc Console #2