Sharp Projector Remote Control setup guide On VCR, U-Matic or Laserdisc Console #2

Page 25

a minute for the projector to warm up. There will be both solid and flashing green lights on the projector.

5.3Once there are 2 solid green lights on the projector indicating that it has warmed up, press the button labeled VIDEO. If the projector is not warmed up it will not come on. Try pressing VIDEO once again if the projector is warmed up but there is still no image on the screen.

5.4If you no longer need the projector, or if it will be turned off for more than 10 minutes, press the blue power button on the remote. This will turn off the projector. Please note that you cannot immediately turn the projector back on. It takes a few minutes for it to cool down and can be turned back on when you see a solid red light on the projector.

***To temporarily turn projector off, press MUTE on the remote. Projector will turn itself back automatically in 10 minutes, or when you press MUTE again.

6.0On VCR, U-Matic or Laserdisc (Console #2)

6.1Power ON to VCR1 (VHS VCR), VCR2 (U-Matic) or LDP1 (Laserdisc).

6.2Insert and start playing video or disc.

7.0Clean up

7.1Power OFF to Projectors.

7.2Remove video or disc from player.

7.3Power OFF to PRIMARY CONTROL.

25

Image 25
Contents Audio/visual equipment setup guide Table of Contents On Primary Control Console #1 Clean upOn Receiver Console #1 On Tape Deck Console #1Initial setup Setting Up and Displaying Laptop Computers RoomOn Switcher Console #1 see Image below and Figure Bl PR0J2 CPU button is for the projector nearest the windows Power OFF to Primary Control On SwitcherUsing the Mitsubishi Portable Projector Cheat Sheet Page Room 111- Cheat Sheet On Switcher Room 111- Step-by-Step Wall Jacks on south wall Macintosh Switcher Page On Switcher Projector Remote Control Should be one in classroom Only one projector can be chosen to display video images On VCR, U-Matic or Laserdisc Console #2 Using the P.A. System in Room 1 1 1 Cheat Sheet Using The Sharp Portable Projector- Cheat Sheet Page Using Video Output in Room 111 Cheat Sheet On VCR, U-Matic or Laserdisc Console #2 On Switcher Console #1 /see Image below and Figure Al Using Video Output in Room 111 Step-by-StepFigure a On Switcher On VCR. U-Matic or Laserdisc Console #2