Sharp Projector Remote Control setup guide Using the P.A. System in Room 1 1 1 Cheat Sheet

Page 21

Using the P.A. System in Room 1 1 1 - Cheat Sheet

Instructions for using the Room 111 public address system.

1.0On PRIMARY CONTROL (Console #1)

1.1Select Power ON (button lit).

1.2Select P.A. SYSTEM ON (button lit). This button is also on the room's podium.

Please Note: The volume knobs on the PRIMARY CONTROL are for the ceiling speakers. The volume knob on the RECEIVER does not work with the public address system.

2.0Clean up

2.1Power OFF to P.A. SYSTEM.

2.2Power OFF to PRIMARY CONTROL.

21

Image 21
Contents Audio/visual equipment setup guide Table of Contents On Primary Control Console #1 Clean upOn Receiver Console #1 On Tape Deck Console #1Initial setup Setting Up and Displaying Laptop Computers RoomOn Switcher Console #1 see Image below and Figure Bl PR0J2 CPU button is for the projector nearest the windows Power OFF to Primary Control On SwitcherUsing the Mitsubishi Portable Projector Cheat Sheet Page Room 111- Cheat Sheet On Switcher Room 111- Step-by-Step Wall Jacks on south wall Macintosh Switcher Page On Switcher Projector Remote Control Should be one in classroom Only one projector can be chosen to display video images On VCR, U-Matic or Laserdisc Console #2 Using the P.A. System in Room 1 1 1 Cheat Sheet Using The Sharp Portable Projector- Cheat Sheet Page Using Video Output in Room 111 Cheat Sheet On VCR, U-Matic or Laserdisc Console #2 On Switcher Console #1 /see Image below and Figure Al Using Video Output in Room 111 Step-by-StepFigure a On Switcher On VCR. U-Matic or Laserdisc Console #2