Sharp Projector Remote Control setup guide On Switcher Console #1 see Image below and Figure Bl

Page 5

4.0 On SWITCHER (Console #1) [see Image below and Figure Bl

Figure B

CPUl CPU2 VCR1 VCR2 LDP1

			Control	I/O
Power
PROJ1	PROJ2	PROJ1 PROJ2	Enter Preset View Esc	RGBS Audio
CPU	CPU	VIDEO VIDEO
Audio
output

4.1Power should be ON (button lit).

4.2Deselect all buttons under the labels CONTROL and I/O (lights above buttons should be OFF).

4.3Under the label I/O, Select the button RGBS (light should come on).

4.4Select button CPU1 or CPU2 (red light should come on).

4.5If any green lights come on elsewhere on the switcher, deselect those buttons.

4.6Select button above label for projector output to be used for computer image projection: (Proji CPU or Proj2 CPU).

PROJ1 CPU button is for the projector nearest the classroom door.

Image 5

Contents Audio/visual equipment setup guide Table of Contents On Primary Control Console #1 Clean upOn Receiver Console #1 On Tape Deck Console #1Initial setup Setting Up and Displaying Laptop Computers RoomOn Switcher Console #1 see Image below and Figure Bl PR0J2 CPU button is for the projector nearest the windows Power OFF to Primary Control On SwitcherUsing the Mitsubishi Portable Projector Cheat Sheet Page Room 111- Cheat Sheet On Switcher Room 111- Step-by-Step Wall Jacks on south wall Macintosh Switcher Page On Switcher Projector Remote Control Should be one in classroom Only one projector can be chosen to display video images On VCR, U-Matic or Laserdisc Console #2 Using the P.A. System in Room 1 1 1 Cheat Sheet Using The Sharp Portable Projector- Cheat Sheet Page Using Video Output in Room 111 Cheat Sheet On VCR, U-Matic or Laserdisc Console #2 On Switcher Console #1 /see Image below and Figure Al Using Video Output in Room 111 Step-by-StepFigure a On Switcher On VCR. U-Matic or Laserdisc Console #2