Sharp Projector Remote Control setup guide Figure a

Page 27

Figure A
Switcher
CPUl CPU2 VCR1 VCR2 LDP1
	Control	I/O
Dower
PROJ1 PROJ2 PROJ1 PROJ2	Enter Preset View Esc	RGBS Audio
CPU CPU VIDEO VIDEO
Audio
output

3.1Power should be ON (button lit).

3.2Deselect all buttons under the labels CONTROL and I/O (lights above buttons should be OFF).

3.3Under the label I/O, Select the button RGBS (light should come on).

3.4Select button VCR1 (for VHS VCR) or VCR2 (for U-Matic) or LDP1 (for Laserdisc) (red light should come on).

3.5If any green lights come on elsewhere on the switcher, deselect those buttons.

3.6Select button above label for projector output to be used for video projection: (Proji VIDEO or Proj2 VIDEO).

•PROJ1 VIDEO button is for the projector nearest the classroom door.

•PROJ2 VIDEO button is for the projector nearest the windows.

**Both projectors can be chosen if both screens are being used for display.

27

Image 27

Contents Audio/visual equipment setup guide Table of Contents On Tape Deck Console #1 Clean upOn Primary Control Console #1 On Receiver Console #1Initial setup Setting Up and Displaying Laptop Computers RoomOn Switcher Console #1 see Image below and Figure Bl PR0J2 CPU button is for the projector nearest the windows Power OFF to Primary Control On SwitcherUsing the Mitsubishi Portable Projector Cheat Sheet Page Room 111- Cheat Sheet On Switcher Room 111- Step-by-Step Wall Jacks on south wall Macintosh Switcher Page On Switcher Projector Remote Control Should be one in classroom Only one projector can be chosen to display video images On VCR, U-Matic or Laserdisc Console #2 Using the P.A. System in Room 1 1 1 Cheat Sheet Using The Sharp Portable Projector- Cheat Sheet Page Using Video Output in Room 111 Cheat Sheet On VCR, U-Matic or Laserdisc Console #2 On Switcher Console #1 /see Image below and Figure Al Using Video Output in Room 111 Step-by-StepFigure a On Switcher On VCR. U-Matic or Laserdisc Console #2