Sharp Projector Remote Control setup guide On VCR, U-Matic or Laserdisc Console #2

Page 20

for it to cool down and can be turned back on when you see a solid red light on the projector.

To temporarily turn projector off, press MUTE on the remote. Projector will turn itself back automatically in 10 minutes, or when you press MUTE again.

8.0On VCR, U-Matic or Laserdisc (Console #2)

8.1Power ON to VCR1 (VHS VCR), VCR2 (U-Matic) or LDP1 (Laserdisc).

8.2Insert and start playing video or disc.

9.0Clean up

9.1Power OFF to Projectors.

9.2Remove video or disc from player.

9.2Power OFF to PRIMARY CONTROL.

9.3Power Off to Workstation.

9.4Disconnect all cables, but DO NOT disconnect the extension cables from either the cpu or the monitor cable.

20

Image 20

Contents Audio/visual equipment setup guide Table of Contents Clean up On Primary Control Console #1On Receiver Console #1 On Tape Deck Console #1Setting Up and Displaying Laptop Computers Room Initial setupOn Switcher Console #1 see Image below and Figure Bl PR0J2 CPU button is for the projector nearest the windows On Switcher Power OFF to Primary ControlUsing the Mitsubishi Portable Projector Cheat Sheet Page Room 111- Cheat Sheet On Switcher Room 111- Step-by-Step Wall Jacks on south wall Macintosh Switcher Page On Switcher Projector Remote Control Should be one in classroom Only one projector can be chosen to display video images On VCR, U-Matic or Laserdisc Console #2 Using the P.A. System in Room 1 1 1 Cheat Sheet Using The Sharp Portable Projector- Cheat Sheet Page Using Video Output in Room 111 Cheat Sheet On VCR, U-Matic or Laserdisc Console #2 Using Video Output in Room 111 Step-by-Step On Switcher Console #1 /see Image below and Figure AlFigure a On Switcher On VCR. U-Matic or Laserdisc Console #2