Sharp Projector Remote Control setup guide

Page 23

for it to cool down and can be turned back on when you see a solid red light on the projector.

To temporarily turn projector off, press BLACK SCREEN on the remote. Projector will turn itself back automatically in 10 minutes, or when you press BLACK SCREEN again.

***lf AUDIO OUTPUT from the workstation is needed, then you will have to use the speakers kept in the storage basket on the cart.

4.0Clean up

4.1Power OFF to Projector. You will need to press either the projector's power button or the one on the remote, followed by turning off the back power button.

4.2Power OFF to computer.

4.3Disconnect all cables. Make sure that the projector's remote and the black SHARP MONITOR cable stay on the projector cart.

23

Image 23
Contents Audio/visual equipment setup guide Table of Contents On Tape Deck Console #1 Clean upOn Primary Control Console #1 On Receiver Console #1Initial setup Setting Up and Displaying Laptop Computers RoomOn Switcher Console #1 see Image below and Figure Bl PR0J2 CPU button is for the projector nearest the windows Power OFF to Primary Control On SwitcherUsing the Mitsubishi Portable Projector Cheat Sheet Page Room 111- Cheat Sheet On Switcher Room 111- Step-by-Step Wall Jacks on south wall Macintosh Switcher Page On Switcher Projector Remote Control Should be one in classroom Only one projector can be chosen to display video images On VCR, U-Matic or Laserdisc Console #2 Using the P.A. System in Room 1 1 1 Cheat Sheet Using The Sharp Portable Projector- Cheat Sheet Page Using Video Output in Room 111 Cheat Sheet On VCR, U-Matic or Laserdisc Console #2 On Switcher Console #1 /see Image below and Figure Al Using Video Output in Room 111 Step-by-StepFigure a On Switcher On VCR. U-Matic or Laserdisc Console #2