Using the Adjustment Feet
The height of the projector can be adjusted using the adjustment feet at the front and rear of the projector.
When the screen is in a higher position than the projector, the projection image can be made higher by adjusting the projector.
1Press HEIGHT ADJUST button.
•The front adjustment foot comes out.
2Lift the projector to adjust its height while pressing the HEIGHT ADJUST button.
•The projector is adjustable up to approxi- mately 12 degrees (5 steps).
•When lowering the projector, it may be difficult to move the front adjustment foot because the installation surface is diffi- cult to slide. In this case, pull the pro- jector back slightly and adjust its height.
3Remove your hands from the HEIGHT ADJUST button of the projector after its height has been finely adjusted.
4Use the rear adjustment foot to make the projector level.
•The projector is adjustable ±1 degree from the standard position.
Note
•When the height of the image is being ad- justed by the adjustment feet, the image be- comes distorted trapezoidally. In this case, see “Correcting Trapezoidal Distortion” on the page 20 to correct the trapezoidal distortion.
Info
•Do not press the HEIGHT ADJUST button when the front adjustment foot comes out without firmly holding the projector.
•Do not hold the lens when lifting or lower- ing the projector.
•When lowering the projector, be careful not to get your fingers caught in the area be- tween the adjustment foot and the projector.
HEIGHT |
| |
ADJUST | Projection | |
button | ||
|
Front adjustment
HEIGHT ADJUST button foot
Rear adjustment foot
-23