Sharp PGB10S operation manual Controlling the Projector Using a Computer

Connecting the Projector to Other Devices

Controlling the Projector Using a Computer

Connecting to a Computer Using a DIN-D- sub RS-232C Adaptor and an RS-232C Serial Control Cable

When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS-232C adaptor (sold separately) and an RS- 232C serial control cable (cross type, sold separately), the computer can be used to con- trol the projector and check the status of the projector. See page 69 for details.

1Connect a DIN-D-sub RS-232C adaptor (sold separately) to an RS-232C serial control cable (sold separately).

2Use the above cables to connect the projector and the computer.

Note

•Do not connect the RS-232C cable to a port other than the RS-232C terminal on the com- puter. This may damage your computer or projector.

•Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your com- puter.

•The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details.

•See page 68 for connection of an RS-232C serial control cable.

DIN-D-sub RS-232C adaptor AN-A1RS

(5 57/64" (15 cm))

Optional

cables

RS-232C serial control cable AN-C10RS

(32'10" (10.0 m))

Computer

DIN-D-sub RS-232C adaptor (sold separately)

	RS-232C serial
	control cable
To RS-232C terminal	(sold separately)

-54