Sharp PGB10S operation manual Setting up the Screen, Standard Setup Front Projection

Setting up the Screen

Position the projector perpendicular to the screen with all feet flat and level to achieve an optimal image.

Note

•The projector lens should be centered in the middle of the screen. If the horizontal line passing through the lens center is not perpendicular to the screen, the image will be distorted, making viewing difficult.

•For an optimal image, position the screen so that it is not in direct sunlight or room light. Light falling directly on the screen washes out the colors, making viewing difficult. Close the curtains and dim the lights when setting up the screen in a sunny or bright room.

•A polarizing screen cannot be used with this projector.

Standard Setup (Front Projection)

■Place the projector at the required distance from

the screen according to the desired picture size. (See page 57.)

Example of standard setup

Screen size : 100 inch (254 cm) STRETCH Mode : 16:9

Side View

cm)(145.2 Screen

/11 "64

H1 57:

H2

-8 1/16"(-20.5 cm)

Top View
Screen
/32 " (65.8 cm)
29
: 25	Center of screen
W
-56

Lens center

Lower lens shift position

(High mount setup)

Lens center

Upper lens shift position (Desktop setup)

Lens center

Leftmost lens shift position

Lens center

Rightmost lens shift position

•The distance from the screen to the projector may vary

depending on the size of the

screen.P.57

•The default setting can be used, when placing the projector in front of the screen. If the projected im- age is reversed, readjust the set- ting to “Front” in the “PRJ Mode”

menu.P.49

•Place the projector so that an imaginary horizontal line that passes through the center of the lens is perpendicular to the screen.