Sharp JW-21MN Description for Computer Link Operation 10-1 to, Errors and Countermeasures 12-1 to

Chapter 10: Description for Computer Link Operation			10-1 to 14
10-1 Computer link function			10-1
[1]	Basic commands		10-1
[2]	Optional commands		10-1
10-2 Basic commands			10-2
10-3 Optional commands			10-3
[1]	Read free memory size		10-4
[2]	Monitor TMR, CNT, and MD		10-4
[3]	Reading PC mode		10-5
[4]	Setting PC mode		10-5
[5]	Reading system memory		10-6
[6]	Writing system memory		10-6
[7]	Reading date		10-7
[8]	Setting date		10-7
[9]	Reading time		10-8
[10]		Setting time	10-8
[11] Correct clock time			10-9
[12]		Monitor step status: JW20/JW20H only	10-9
[13]		Read the optional parameters	10-10
[14]		Set the optional parameters	10-10
[15]		Read the special I/O parameters	10-11
[16]		Set the special I/O parameters	10-11
[17]		Set the secret function: JW30H only	10-12
[18]		Release the secret function, register password: JW30H only	10-12
[19]		Check the secret function: JW30H only	10-13
[20]		Response on error	10-14

Chapter 11: Setting of Switches and Parameter		11-1 to 28
11-1	Operation procedure	11-1
11-2	Switch setting of master station and slave station	11-2
[1]	Mode switch (MODE)	11-2
[2]	Module No. switch (UNIT NO.)	11-2
11-3	Setting contents of master station parameters	11-5
[1]	Setting contents	11-5
[2]	Communication area map	11-7
[3]	Setting range of relay link area, register link area, and flag area	11-11
[4]	Setting procedure	11-13
11-4	Setting slave station parameters (common for all slave stations)	11-22
[1]	Setting contents	11-22
[2]	Setting range of flag area	11-23
[3]	Setting procedure	11-24

Chapter 12: Errors and Countermeasures		12-1 to 7
12-1 Indication lamps		12-1
12-2 Flag		12-2
[1]	Flag table	12-2
[2]	In the case of a master station	12-3
[3]	In the case of slave station 01 to 77(8)	12-4
[4]	Monitor operation condition by each station PC	12-5