Sharp JW-21MN Support Tools, Record and load by ladder software JW-92SP, JW-50SP Record, 14-1

JW-22KC/24KC

Connection cable

JW-50SP

Chapter 14: Support Tools

The following support tools are available to record (store), and load the contents of the parameter memory.

(Make sure to save the set parameters onto a floppy diskette.)

Model name	Applicable floppy diskettes
Ladder software (JW-92SP, JW-50SP)	3.5-inch 2DD/2HD, 5-inch 2DD/2HD
Multipurpose programmer (JW-50PG)	3.5-inch 2DD
Ladder processor II (Z-100LP2S)	3.5-inch 2DD

Record and load by ladder software (JW-92SP, JW-50SP) <Record>

(1)Stop operation of the JW-21MN Select "PC TRANS."

Select "Read."

Select "DL. M. stn. PARAM." or "DL. S. stn.

PARAM."

When the connected JW-21MN is master station, select "DL. M. stn. PARAM." When the connected JW-21MN is slave station, select "DL. S. stn. PARAM."

After selecting "PC stop," press the "Enter" key.

JW-21MN

(2)Record onto the personal computer

After stopping operation, record the parameters of the JW-21MN onto the memory of the personal computer. Select "Read out PARAM" and press the "Enter" key.

Start reading to memory of the personal computer.

(3)Start operation of the JW-21MN

After recording the parameters onto the personal computer, start operation of the JW-21MN. Select "Start operation."

Start operation of the JW-21MN

(4)Record onto a floppy diskette

Write (record) the memory contents of the personal computer onto a floppy diskette.

Select "FD TRANS."

Select "Save."

Select "DL. M. PARAM." or "DL. S. PARAM."

When the memory contents of the personal computer are for a master station, select "DL. M. PARAM." When the memory contents of the personal computer are for a slave station, select "DL. S. PARAM."

Input a file name to record.

14

Input comments.

Press the "Enter" key.

Start recording onto the floppy diskette.

14-1