Sharp JW-21MN manual 11-26

11

From the previous page

"Only when using save memory function"

V2 Set the number of sending bytes of the relay link in save memory function [DCM (decimal), word]

Set the number of sending bytes in decimal on the parameter address 007720 to 007721(8).

007200(8)	Lower
007721(8)	Upper

- In case of setting 4 bytes (Example for page 11-10)

				Display the contents of parameter addresses 007720 to
				007721(8)
			Write 00004(D) after converting to decimal
Screen display of JW-14PG
	07714	D	00000	007720(8)
	07716	D	00000		00004(D)
	I PARAM.			007721(8)
	>07720	D	00004

"Only when using save memory function"

V2 Set the number of receiving bytes of register link in save memory function [DCM (decimal), word]

Set the number of sending bytes in decimal on the parameter address 007722 to 007723(8).

007722(8)	Lower
007723(8)	Upper

- In case of setting 8 bytes for parameter addresses 007722 to 007723(8). (Example for page 11-10)

Display the contents of parameter addresses 007722 to 007723(8)

Write 00008(D)

Screen display of JW-14PG

07716	D	00000	007722(8)
07720	D	00000		00008(D)
I PARAM.			007723(8)
>07722	D	00008

V2 Set whether the station number information should be output or not

Set whether the station number information should be output or not on the parameter address 007763(8).

007763(8)

To the next page

Whether the station number information should be output or not

00(H): Do not output

01(H): Output

The station number information is output on the next byte of the flag area (24 bytes.)

This setting is valid when the parameter address is 007767(8) = 80(H).

11-26