Sharp AL-1340 operation manual Description of Special Functions, Toner Save Mode, Preheat mode

Page 25

4 SPECIAL FUNCTIONS

DESCRIPTION OF SPECIAL FUNCTIONS

This chapter describes the special functions of this copier. Use these functions as needed.

Toner save mode (page 23)

Reduces toner consumption by approximately 10%.

Power save modes (page 24)

The copier has two power save modes of operation: preheat mode and auto power shut-off mode.

●Preheat mode

When the copier enters the preheat mode, the power save ( ) indicator will light up and other indicators will remain on or off as before. In this condition, the fuser in the copier is maintained at a lower heat level, thereby saving power. To copy from the preheat mode,

make desired copier selections and press the print (	) key using the normal copying
procedure.

●Auto power shut-off mode

When the copier enters the auto power shut-off mode, the power save ( ) indicator will light up and other indicators will go out. The auto power shut-off mode saves more power than the preheat mode but requires a longer time before starting copying. To copy from the


auto power shut-off mode, press the print (		) key. Then make desired copier selections
and press the print (	) key using the normal copying procedure.

Auto clear (page 24)

The copier returns to the initial settings a preset amount of time after the last copy is made. This preset amount of time (auto clear time) can be changed.

TONER SAVE MODE

1	Press the exposure mode selector key to select the manual (	) mode.
1

4

Special functions

23

Image 25

Contents AL-1340 Or 1-877-SHARP-CC toll free/905-568-7140 in Canada For Your ProtectionContents Appendix Introduction Getting StartedConventions used in this manual High-speed laser copying Main FeaturesHigh-quality digital image Substantial copying functions Printer featureScan once/ Print many Environmentally friendly designPart Names Operation Panel Copier Installation InstallationDo not touch the surface green portion of the drum cartridge Unpacking Checking Packed Components and AccessoriesRemoving Protective Packing Materials Installing the TD CartridgeOn both sides and shake it horizontally four or five times Loading Copy Paper installing the paper tray Hooks Power to Copier Initial settings of operation panel Power onPaper Making CopiesNormal Copying Setting a large original REDUCTION/ENLARGEMENT/ZOOM Exposure ADJUSTMENT/PHOTO CopyingBypass Feed special paper To select a preset copy ratio To select a zoom ratioTWO-SIDED Copying Preheat mode Toner Save ModeAuto power shut-off mode Special FunctionsUser Programs Setting the power save modes and auto clear timeOFF TD Cartridge Replacement Supplies and User MaintenanceTD Cartridge Drum Cartridge ReplacementCabinet User MaintenanceTransfer charger Original table and original coverWhen copier is not in use Misfeed Removal Copier TROUBLE?Misfeed in the paper feed area Lower the fusing unit release lever Misfeed in the fusing areaMisfeed in the transport area Problem Possible cause Solution See TroubleshootingDisplaying Total Number of Copies Status IndicatorsIndication Cause and remedy See Automatic Exposure Adjustment Appendix SpecificationsSupply list Supply Part Numbers and StorageProper storage Moving Instructions TD Cartridge ReplacementNames IndexPacked components Paper Loading Special Memo For users in the USA Sharp Electronics Corporation