Sharp AL-1340 operation manual Supplies and User Maintenance, TD Cartridge Replacement

Page 28

5

Supplies and user maintenance

5 SUPPLIES AND USER MAINTENANCE

This chapter describes how to replace the TD cartridge and the drum cartridge and how to check the total number of copies.

Be sure to use only genuine SHARP parts and supplies.

TD CARTRIDGE REPLACEMENT

The TD cartridge replacement required ( ) indicator will light up when toner is needed. For more information on purchasing the TD cartridge, see SUPPLY PART NUMBERS AND STORAGE on page 38. If copying is continued while theindicator is lit, copies will gradually become lighter until the copier stops and the indicator begins blinking. Replace the old TD cartridge by following the procedure given below.

●After the copier stops, it may be possible to make a few more copies by

taking the TD cartridge out of the copier, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the TD cartridge.

●During long copy run of a dark original, the ready () indicator may blink, the indicator light up, and the copier stop, even though toner is left. The

copier will feed toner up to 2 minutes and then the ready () indicator will

light up. Press the print () key to restart copying.

1

Open the side cover while pressing the side cover open button.

Then, push gently on both sides of the front cover to open the cover.

 

2

Gently pull the TD cartridge out while pressing the lock release button. Dispose of the

old TD cartridge in accordance with local regulations.

 

Lock release button

26

Page 27 Page 29
Image 28
Page 27 Page 29
Contents AL-1340 For Your Protection Or 1-877-SHARP-CC toll free/905-568-7140 in CanadaContents Appendix Introduction Getting StartedConventions used in this manual High-speed laser copying Main FeaturesHigh-quality digital image Printer feature Substantial copying functionsScan once/ Print many Environmentally friendly designPart Names Operation Panel Installation Copier InstallationDo not touch the surface green portion of the drum cartridge Checking Packed Components and Accessories UnpackingInstalling the TD Cartridge Removing Protective Packing MaterialsOn both sides and shake it horizontally four or five times Loading Copy Paper installing the paper tray Hooks Power to Copier Power on Initial settings of operation panelMaking Copies PaperNormal Copying Setting a large original Exposure ADJUSTMENT/PHOTO Copying REDUCTION/ENLARGEMENT/ZOOMTo select a preset copy ratio To select a zoom ratio Bypass Feed special paperTWO-SIDED Copying Toner Save Mode Preheat mode Auto power shut-off mode Special FunctionsSetting the power save modes and auto clear time User ProgramsOFF Supplies and User Maintenance TD Cartridge ReplacementDrum Cartridge Replacement TD CartridgeUser Maintenance CabinetOriginal table and original cover Transfer chargerWhen copier is not in use Misfeed Removal Copier TROUBLE?Misfeed in the paper feed area Misfeed in the fusing area Lower the fusing unit release leverMisfeed in the transport area Troubleshooting Problem Possible cause Solution SeeDisplaying Total Number of Copies Status IndicatorsIndication Cause and remedy See Automatic Exposure Adjustment Specifications AppendixSupply list Supply Part Numbers and StorageProper storage TD Cartridge Replacement Moving InstructionsIndex NamesPacked components Paper Loading Special Memo For users in the USA Sharp Electronics Corporation
Top Page Image Contents