STATUS INDICATORS
When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the relevant page.
Be sure to use only genuine SHARP parts and supplies.
| Indication |
| Cause and remedy | See |
|
|
| page: |
| ||
|
|
|
|
| |
|
| Steadily | Replacement of drum cartridge will be needed | 38 |
|
| Drum replacement | lit | soon. Prepare a new cartridge. |
|
|
| required indicator |
|
|
|
|
| Blinking | Drum cartridge must be replaced. Replace it | 27 |
| |
|
|
| |||
|
| with a new one. |
|
| |
|
|
|
|
|
|
| TD cartridge | Steadily | Replacement of TD cartridge will be needed | 38 |
|
| lit | soon. Prepare a new cartridge. |
|
| |
| replacement |
|
| ||
|
| TD cartridge must be replaced. Replace it with | 26 |
| |
| required indicator | Blinking |
| ||
|
| a new one. |
|
| |
| Misfeed indicator | Blinking | A misfeed has occurred. Remove the misfed | 31 |
|
| paper referring to the description of “Misfeed |
|
| ||
|
|
| removal.” |
|
|
| “CH” is blinking in the display. | The TD cartridge is not installed. Check if the | 26 |
| |
|
|
| cartridge is installed. |
|
|
| “CH” is steadily lit in the | Side cover is open. Close the side cover | — |
| |
| display. |
| securely by pressing the round projections |
|
|
|
| near the side cover open button. |
|
| |
|
|
|
|
| |
|
|
|
|
|
|
|
|
| Paper tray or bypass tray is empty. Load copy | 13 |
|
|
|
| paper. |
|
|
|
|
|
|
|
|
| “P” is blinking in the display. | A misfeed has occurred in the paper tray or | 31 |
| |
| bypass tray. Remove the misfed paper. |
|
| ||
|
|
|
|
| |
|
|
|
|
|
|
|
|
| Paper tray is not securely installed. Push the | — |
|
|
|
| tray in securely. |
|
|
|
|
|
|
|
|
| A letter and a number appear | The copier will not function. Turn the power | — |
| |
| switch off, remove the power cord from the |
| |||
|
|
| |||
| alternately. |
| outlet, and contact our Technical Assistance |
|
|
|
|
|
|
| |
|
|
| Department at |
|
|
|
|
|
|
| |
|
|
| Canada. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
1 | Press the clear ( ) key to reset the display to zero. |
|
Press and hold down the clear (
) key for approximately 5 seconds.The total number
2 of copies will appear in two steps, each with three digits. Example: Total number of copies is 1,234.
6
Copier trouble?
35