Sharp UP-820F, UP-820N manual Programming of the MWS terminal number

Page 53

9.Programming for the Manager Work Station (MWS)

– master and satellite

The LAN interface for the UP-820F/UP-820N POS enables the UP-820F/UP-820N to perform in-line communications to a host P.C. through the connection to a Manager Work Station (MWS).

For the setup of the Manager Work Station, please be sure to consult your authorized SHARP dealer.

The function of Manager Work Station:
1)	Downloading of the terminal data	[Terminal				PC]

2)	Uploading of the terminal data	[Terminal				PC]

3)	Remote Job Entry (RJE) function	[Terminal				PC]

4)	T-LOG function	[Terminal				PC]

5)	ELECTRONIC MAIL function	[Terminal				PC]

(1) Programming of the MWS terminal number

The terminal number of MWS can be specified by the following procedure:

1. Enter the PGM2 mode from the mode selection window.

2. Select “SETTING” and press the ekey. The SETTING window will appear.

3. Select “MWS CONFIG” and press the ekey. The MWS CONFIG window will appear.

4. Move the cursor to the “IP ADDRESS 4” line.

Enter the terminal number (0-254) in the IP ADDRESS 4 line of MWS and press the ckey.

•Entering a terminal number of the machine itself results in “ENTRY ERROR”.

51

Image 53

Contents UP-820F UP-820N Page Table of Contents Page Introduction Message displayed during inline communication Message displayList of error messages Error messagesOpen store operation Opxz mode master and satellite Close store operation Opxz mode master and satellite Centralized clerk file system Clerk systemIndividual clerk file system Clerk assignment Sign-on operation clerk assignment REG mode/MGR modeSign-on procedure Clerk sign-on report Report generation procedureCashier sign-off procedure Sign-off procedureInitial downloading Maintenance downloading Downloading Jobs Description List of downloading jobs PGM2 modePage Individual GLU file system Look-up and updating of the GLU fileCentralized GLU file system Individual system PLU/EAN stock controlCentralized system LOG polling Stored in its T-LOG buffer PLU/EAN data controlUpdating Updating learning function Customer data control Price change functionSecond back-up remote printer Communication with a remote printer optionRerouting print data Operating modes Consolidated and Individual ReportsConsolidated reports master/back-up master Report generation procedureDepartment DEPT. /GROUP List of consolidated reports System READING/RESETTINGPersonnel ALL Clerk Individual reports master/back-up master/satellite List of individual reports READING/RESETTING Journal Resetting reports in a system with no save file Clerk report Sharp dealer Cashier report Type of report Clerk/Cashier Reset clear operation X1/Z1 and X2/Z2 modes master IRC Programming Setting the machine numbers master and satellitePage Page Master list for IRC communications Deleting a machine from the master listSpecifying the terminal to serve as a back-up master master Unsuccessful transmission depending on the selection made Page Page Sample Print satellite Programming for the remote printer BUILT-IN820 BUILT-IN810 Auto Cutter Items to be programmedPage Separator Line Programming of the MWS terminal number Programming of the gateway number Programming of the time-out timeTerminal No Time-out time 7 sec Gateway No How the IRC back-up system works System Back-UpFlow of a master declaration at the back-up master Master declarationPage Flow of a master declaration at the master Flow of a recovery declaration at the back-up master Recovery declarationPage Flow of a recovery declaration at the master Manual clear operation Manual clearing procedureClearing procedure Description Terminal*1 Remarks List of manual clearing itemsSystem retry function When the system retry function is disabledWhen the system retry function is enabled Basic Specifications for LAN UP820F820NV2IE10

Related manuals

Manual 242 pages 54.69 Kb

Manual 242 pages 43.78 Kb

Manual 277 pages 4.18 Kb